开云体育

where the hell do i find these?,there is no drivers section on the wiki files section,seems a pisspoorly organised site!!

But the group the group is configured as: Visibility: Group listed in directory, publicly viewable. But I don’t see any reason that the *content* messages should be hidden from Google. Removing

By googeling for some term, without being registered, you will get groups.io messages without any problem. So even as groups.io is thought to be group-private: It isn't. If you don't like that, imho

yeah Andy, do you think everyone is a pc guru? people come here to ask for help, not education. Successful use of linux until the first downfall. :D :D 73, Gyula

Use Zadig 2.4 to get USB STM32 downloader driver and STM32CubeProgrammer for downloading the nanovna firmware 0.5.2 into the device. Op za 30 nov. 2019 om 09:04 schreef Andy via Groups.Io

It's Windows, what else do you expect ? Meanwhile in Linuxland...drivers..we don't need no stinkin' drivers ;-) - Andy -

Interesting... Over the past week I have casually reviewed various Li-Ion data sources, and I've seen surprising variations. Up until recently, I had assumed that it was typical to charge a Li-Ion

Hi Roger, The device manager shows the driver when it is working properly. There are more ways to see what's hidden. What I recommend is a utility called USBDeview, which shows you what driver

Yes,I have done the same. 1st test was my Tecsun PL660. The input was about 500 ohms through the external antenna socket. Spec sheet for the SDR chip said about 600 ohms, so that seems in order, since

Roger, Checkout the "Drivers" section of this group's "Wiki" page, /g/nanovna-users/wiki/home . -Herb

ajparent1/kb1gmx wrote: So go to the local electronics recycler, junk store, or pawn shop, friend's junk pile, or whatever, expend maybe $20 or $30 for something the pawn shyster can't sell because it

I just received delivery of a NanoVNA-H and it works well stand-alone. I tried to hook it up to my Windows 8.1 PC and ran unto problems. The driver is not able to install so I can't connect to

I bought one at a very low price from Walmart.? It was shipped promptly and works perfectly.? It did not come with the usual two coaxial cables but otherwise I am happy with it.? The 50 Ohm load is

I have received feedback from multiple resellers, and a new clone manufacturer is selling them low-quality NanoVNA clones at a lower price. They have not tested before leaving the factory, and they do

If your trying to test an antenna against a small ground plane anything attached to the test setup extends the ground plane side of the antenna. The ground plane for a monopole is effectively the

I wrote a lot of useful DOS-based Quick BASIC programs many years ago but nowadays needed DOSBox to run them under Windows. Today I discovered that QB64 running on my Windows 10 PC will take those

Hello Ulrich I look s like you load is not 50 ohm. In the calibration you tell the NanoVNA is at center position whatever value it has Kind regards Kurt -----Oprindelig meddelelse----- Fra:

Hi Betex This is quite simple to understand why as the cable from you feeding point of the antenna incl. the NanoVNA with or without the USB cable is constituting a sort of dipole where the whip under

if calibration is ok, then also possible defect in OPEN load. Try to calibrate with open connector instead of OPEN load.

did you performed CAL => RESET before calibration?