开云体育

have an H4 nano that has been working just fine with my W10 x64 for the last couple of years. Then one day a week ago it will nolonger connect to saver. It attempts to connect 10 times then quits. I

Thanks. Since you develop the firmware. Do you know the latest hardware revision of the NanoVNA H4 (serial number)? Or if any updates are planned?

I didn't even realize that the application handles not just a bin, the hex and dfu files... beginners guide newer version in the file section:

dislords version is more actual owenduffy stops at 209 while dislord is at 215 https://github.com/DiSlord/NanoVNA-App/blob/main/Win32/Release/NanoVNA-App.exe greetz sigi dg9bfc Am 10.07.2023 um 23:15

Andrea, The easiest way to upgrade is to use the built in firmware update feature in NanoVNA app which works with bin or dfu files. It is a Windows application that interfaces with a NanoVNA and is a

** A coaxial cable has two ends. For you, it starts on which side? I'm sure it doesn't start on the same side for everyone :) -- Fran?ois De la part de Dave (NK7Z) Envoyé : dimanche 9 juillet 2023

This will help for You: https://github.com/The6P4C/dfuse-extract

Hello, What is the latest hardware version of the NanoVNA-H4? And is there a (minor) update planned, such as protection diodes, or something similar? Best regards, Ma?l H?rz

Hi. I know that this topic has been covered a lot. However I can't make my NanoVNA be recognised by my PC running Windows 11 64-bit (latest version) using the DFU SE. Please note: 1) I have read and

I forgot to mention, by feedpoint, I mean the point where the coax begins. If a dipole, right after the center insulator, if a vertical, right after the coax starts, and on the coax, if an antenna

Hi again, Once you have added the ferrite material, check by putting the nano down, and picking it up again. If the frequency still slides around try increasing the number of turns until you see no,

Totally depends on the design of your antenna. With something like a ground plane antenna, your had should do little. A Yagi antenna with a Balun, your hand should do little. HF Dipole with a Balun,

Hi, This indicates you have become part of the antenna system... It also indicates you might consider adding a good 1:1 choke at the antenna feedpoint, and try the test again. I would guess you will

Interesting. So should I be sure to avoid contact with the nanovna while observing or tuning the antenna swr?

You were part of the resonate circuit of the antenna. You were a? Counterpoise! Virtually every talkie is depending on the operators hand to be the other half of the antenna. Kent WA5VJB?? Antenna

Hi. I have set and calibrated the nanovna and then hooked up my antenna to see the SWR graph. Let's say I have a 20m antenna attached and it shows a nice dip at 14.45Mhz to swr of 1.2. all this time

NanoVNA-h and H4 sources open https://github.com/DiSlord/NanoVNA-D And yes colors possible change only from console

To clarify, I mean from within the NanoVNA GUI itself, as what I found requires using the console, which makes experimenting with colors difficult. References to change colors over the console:

Hi, Is it possible to set the trace colors in DiSlord's firmware (still waiting for another question before deciding which model to buy)? Other colors can be more suitable and contrasting in some

On most firmware versions, the averaging or bandwidth settings can be manipulated to give longer settling time at each frequency step. This helps for narrowband devices. --John Gord