开云体育

You use my fw on V2Plus4? In v1.1 i extend points count to 401 and port all features from H/H4 (all V2 models), XTAL measure not work on V2Plus4 (you not see correct measure on display). Measure on

Hello DiSlord, Thank you! This is exactly the information I was looking for! I appreciate your response and your excellent NanoVNA firmware work. I updated all three of my units (H4, SAA2N and

Also i write on this forum (need translate from Russian): Cable measure and renorm

CABLE - this cable measure util, need calibrate nanoVNA and connect cable (there should be nothing on the other end of the cable) NanoVNA measure cable wave impedance, length (need setup correct

Interesting. NanoVNA firmware is heading towards being an operating system that hides the details of the underlying hardware but still delivers comparable capabilities. - Roland 9V1RT

Top is the Tram RG8X on Transform sweep. Bottom is the Tandy RG8 on transform sweep. I haven't set up for another S21 check yet, but can anyone see anything in here that I might be missing?

I did some work attempting to measure crystals with the original Nano. https://youtu.be/scZ3kZ4Q2sQ?list=PLZSS2ajxhiQD2gftdurGQoyGpUM_HobNI&t=1232

Alan, I love your videos, some of the best, and I have learned so much from them!

Thanks Larry. The google result doesn't seem to come up with anything *specific* about how DiSlord's implementation of these measurements are intended to be used. And the second link which points to a

also, have a look here: /g/nanovna-users/message/20788

Alan, Would a simple google search help?https://www.google.com/search?client=firefox-b-d&q=+L%2FC+MATCH%2C+CABLE%2C+SHUNT+LC%2C+SERIES+LC+and+SERIES+XTAL+howto Looks like there's useful info. Also -

I've done a bit of searching through the past messages, but haven't found what I'm looking for.... I've recently updated my unit to DiSlord's v1.0.69, and there are a lot of interesting new features.

The GitHub says windows software, so I can only imagine it only works on windows. 73, Willie N1JBJ

Yes the best is to ask to Joe Smith is one wonderfully fellow and very fund on the sobjet, I learned one lot from him. I give one good advice read please the manual bifore you ask any question to him

Roy, since it's based on Labview, it may run under any OS that Labview has been ported to. Best to ask the author, Joe Smith at EEVBLOG (

I'm *not* one software specialist, better define myself computer illiterate. *Sent:* Tuesday, November 30, 2021 at 3:15 PM *From:* "Roy J. Tellason, Sr." <roy@...> *To:*

is based on LabWiu software, I use on window 10. *Sent:* Tuesday, November 30, 2021 at 3:15 PM *From:* "Roy J. Tellason, Sr." <roy@...> *To:* [email protected] *Subject:* Re:

I use on window 10

Looked that stuff over, and it looks pretty interesting. Is that software windows-only? I don't run windoze here at all... -- Member of the toughest, meanest, deadliest, most unrelenting -- and ablest

Testing MARCONI Filter 400Mhz to 1.2Ghz with NanoVNA classical Version: 0.8.0 sweep 1Mhz to 2Ghz 101p.