开云体育

not sure how quoting works here but @Larry Rothman From the link above. I installed the v2.2 firmware. The one that is not sold anymore. Problem is still the same Then I installed one above it (v2

Valinire in previous post said to use the following for the s-a-a-2 One is the comm port and the other is the firmware Here is the links

Config-version only displays the version of FW you installed into the device. If you installed plus FW into a non-plus device, you will see 'plus' on the version screen. So - you need to install the

Config - Version says NanoVNA v2 Plus. I just tested ALL the firmwares listed on that site I linked. 2 of them did not work at all, 2 were super slow and rest were working but still with my problem.

Are you sure you have a plus version? The firmware for regular V2 and V2Plus is different (but work, not good work).

I tried with those sma calibration things and I also calibred with 50ohm resistor I also tried open so without any connection short, I shorted sma center to threads and load was 50ohm resistor

There is a similar effect when you upload the plus version firmware to the non plus hardware.

The saa-2n doesn't use dfu for flashing.? Please search the forum messages for: SAA-2N firmware? And you should find the info you need.? Please remember that this forum is primarily for the NanoVNA

So I tried following the procedure in the absolute beginner guide in order to update the firmware on my SAA-2N. I noticed when connecting it to my PC it shows up as USB Serial Device (COM3) and when I

I always calibrate with as many connections and cables attached as I can to eliminate insertion loss. I never considered delay as a factor, which I will now have to research.

It looks like the calibration parts and or a cable or 2 might be defective.? This has tripped-up users in the past with the same display output.? Check all your call components.? On Tue., 14 Sep.

I would also agree on checking connections. when i ever have not a tight connection to whatever I am testing I get that birds nest mess of lines also. Joe WB9SBD

Also check what version of firmware you have. Current version is 1.0.69 De K8HTB Joe

Not sure what frequency you are measuring but first do a reset all. In menu buttons. Set the stimulus 1 MHz to 10 MHz? just for some low hf range. On the s-a-a-2 my SAA2 port zero is the bottom

Yea. Reseted all before ecah cal. Did cal reset and tried reset all and started all over...

Did you do a reset before each cal? Dave - W?LEV -- *Dave - W?LEV* *Just Let Darwin Work*

Hello. Got my hand on this nanovna v2 plus(?) Frist time turned it on got ALOT of traces and no idea what to do. After some tutorials I realased that it might be broken / bricked. As you can see from

Sorry Larry, I had to run out for an appointment and forgot to snip message. Mike N2MS

Thanks, I've updated mine and it works great as well! M

Thanks to all!