开云体育

You can do that (I have) but the best way is to calibrate the unit with the adapters installed to move the reference plane to account for them.

I assume when everyone is using adapters they adjust the electrical delay to account for these?

I took a closer look and there are more of these interferences. They are very narrowband. If the measuring point falls farther than the filter band, they are not there. It has nothing to do with the

Hello Phil! Have You read a File Section? /g/nanovna-users/files/Absolute%20Beginner%20Guide%20to%20The%20NanoVNA Your device NanoVNA H4 (not H3) and Firmware Version 1.0.45 from

Confirming that "-H" variant works on the "Classic" NanoVNA. Just updated it after reading this thread. Compared with crystal measurements done on SAA-v2 with OjisanKobou FW. There is a little bit of

Colours can only be set through the console when connected to a PC, and the saved.? Please read up on searching the forum - it's the first link at the top of the wiki.? A search of console and color

I have just got an H3 Nano VNA its running ver 1.0.45 (Jan 2021 by @Edy555) of the firmware and when I received I was sure the Traces were all separate Colors (But I may have been mistaken) now

DELAY has to be understood here as "Group Delay". It highlights the transit time of a signal through a DUT (Device Under Test) versus frequency. It is usually currently related to transmission

Mario, The 'classic' includes all NanoVNA models from the very 1st model (and clone) up to and including the H (but not the H4). I'm running the latest 1.0.69 on my classic with no issues.

Which variant (if any) works with the Classic (Pre-H) VNA. This never seems completely clear from the descriptions - I think because there's no consistent way to describe the original unit. thanks, M

The wiki page Home ( /g/nanovna-users/wiki/12336/150810 ) has been updated by Larry Rothman <nlroth@...>. *Reason:* Added document link to post on measured parameter

Joe, Many of the questions you keep asking are in both the forum wiki and the various user guides in the forum files section.? Please read the user guides.? start with the Absolute Beginners

I have gotten some great input about this, but it remains a problem that such outputs as “real” and “imaginary” come with no documentation as to what they are. I have written a 1 pager that

I think you will find this video by W2AEW on measuring crystals with a NanoVNA interesting. His videos are technically accurate, easy to follow and quite informative. He uses an earlier version of

So far what I have is CONFIG, SAVE saves: Touch screen cal Grid color Trace color Flip display CALIBRATE, SAVE# saves (per #): Frequency range Sweep points Calibration Error Correction Trace settings

Joe, I suggest you read the Absolute Beginners Guide to the NanoVNA. Your question and many others that new users ask are described in detail. It is in the files section of this group.

Same answer to both questions: yes, saving in 0, 1, 2, 3, or 4 lets you open that calibration any time using the RECALL command. And if you set up all the traces you want during a calibration, and

Thanks! Now does this recall all the stuff including the calibration etc.? Joe WB9SBD

Recall menu Allow recall saved calibration slot

I add this feature for all H/H4/V2/V2Plus in my last v1.0.69 See Marker->Measure menu Unpack and use firmware for your device variant