开云体育

The SA612 currently run on 5volt. Max is 8 volt. Will not make a big difference in performance. IIP3 and 1DBC improvement but more noise. Will do some more testing.

Thanks Jeff, near but not quite, It gives the R in terms of ohms, but the X in terms of pF?? Yes I can get there, but it would be nice to see the Mag R in ohms and the X in terms of j like my itger

Would “uncertainty of errors correction terms” not be a better title?

Please explain edy 0.2.3 SW Thanks Mel, K6KBE

Jeff, I'm running edy 0.2.3 and it will display R and X.

At 200 MHz it appears to be 55 dB (see attached picture).

#45 : errors instead of "errors" : [NanoVNA] Indications for "standard" Nominal Values Hello, Allow us, please, to demonstrate the big difference between Indications and Nominal Values for [AnyVNA],

Herb, John Gord is on the right track about the phase. To be a bit more specific, the phase angle from -180 to 180 degrees in Excel is converted using atan2(im,re) which is the four quadrant arc

Erik, photos at msg 4295. A local regulator is used, adjacent to the mixer. Maybe a separate, local regulator could be used at each mixer to decouple them from the common supply? Awaiting your

Ltd <drkirkby@...> wrote: I hesitate to /instruct/ anyone on firmware, but I have some thoughts to share. tl;dr There is a minimum set of skills that should be in place before

Hi Mel, good to see you (and your Bauer) on the group. I just took a look at my NanoVNA (which I've had for a month or two, so it doesn't have the latest firmware), and I don't see any way to display

Erik,The Japanese Ham on twitter (I put photos in the files section) was running CH0 from an ext supply per the top photo. What would happen if you raised the supply voltage? It can take 8v max.?The

Those 2 resistors are only required if you are using a usbc to usbc cable on a usbc computer port as they tell the computer the type of device being connected. If you're using a usb3 to usbc cable on

I had uploaded a zipped file in the Forum's file section that has info on the matching pad, if you would care to look at.? On Mon, 14 Oct 2019 at 12:14 AM, Starsekr via

Hi Herb The s1p and s2p files are plain txt files so you can open then directly from Excel, choosing a separator then you can save tocsv. However the first 4 lines are text telling what type of data

If you change just firmware for Z0=75 ohm it won't work for 75 ohm properly. It may show you proper resistance for zero reactance circuit (such as dummy loads and resistors). But if your circuit

On Sun, Oct 13, 2019 at 10:12 PM, John Gord wrote: ….. "To get dB, you compute 20*log(sqrt( real^2 + im^2)), or equivalently > 10*log(real^2 + im^2). > 10 * log (0.019876752^2 + 0.001359617^2) =

Hi David, the firmware is written in C. I don't know that there are formal constraints, other than what the license (GPLv3) puts on it. I personally, as an application developer, have a few

There are some features that I would like added to the firmware connected with calibration. I don’t mind making them public, but are quite happy to just add them for my own use. Are there any

Indeed, that is the question, and I >>suspect<< is why some notice more reliable nanoVNA connections via USB-2 hubs than to USB-3 hosts. USB-C connectors are mechanically symmetric. In order for half