¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: info update


 

Do not use hugen's Oct 2 'AA' firmware versions.?They cause the nano to lock-up after touchscreen calibration.?I have the 'CH' version installed and it is working so far
Remember to do full calibration after installing new firmware.?



On Fri, 4 Oct 2019 at 5:30 PM, in3elx@...<in3elx@...> wrote: Thanks for all these info, compliments.

This interests me:
"DMR_M_10KHz_sept-13-19.dfu
Such as these were for enhancements, in this case 10KHz instead of 50KHz minimum.
I >>guess<< many enhancements are in Gen Hu Oct 2 firmware"
- Should this be installed before or after the firmware?

- Which firmware can be used to set an impedance different than 50 Ohm?

Join [email protected] to automatically receive all group messages.