开云体育

South Bend milling slide refurbish. This was from the same arson salvage as the lathe.

1950 Farmall H farm tractor stuff. Remachined the steering gland nut that looked like it had been serviced with a jackhammer. One wired mini alternator install with a proper wrench-flatted heim joint

I designed, machined, assembled and tested this chemical ionization electron impact ionizer for a quadrupole mass spectrometer. 304 series stainless steel, nickel screen, machinable ceramic, vespel

I changed the subject line so it's not so long, more in line with other groups.? Hopefully this makes it easier to find things. If there's any issue with this, we can put it back as it was.

The cutoff blade holder for my lathe came with a missing clamp, I would normally grab a piece of drill rod to make something like that but that was on the other side of the ocean. Here I have to learn

To me the tiny tee slot is not useful. I even on Tiag website to see if they show anything on tee slot *nothing*. It is lessthan ?" [3mm] wide maybe wider. I am thinking some very important to spend

Clamping an angle plate or stop in place. Bill in OKC? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by:Good judgement comes from experience. Experience comes from bad judgement.?SEMPER

I have tee slot It good size maybe for a ? [14mm] bolt. This one is less than a #5 [4mm] screw just to small even for a stop in my view. I am use to a lot bigger too where using ? bolts and a

No different than the t-slots on a shaper knee.

My thoughts are that they could be used for end stops or other attachments for fixturing.

Depends on your distance from the equator. Changes in latitude, changes in attitude.

That may be a standard steel shape that they just buy off the shelf.? Like extrusion profiles, only machined. Aluminium Profile from Matara UK | In-House Machining

*Try this for time and earth 360°* *& try this for time at different Latitudes* One hour is 1020 miles how about one minute At 0° = 17 miles in minute at 35° = 14 miles in minute at 65° = 7.2

Any know how this tee slot use for ? It about Suze if a #6 screw Dave

*More photos on* *mounting the ATTACHMENT* ** **

*Sites for low* *cost milling attachment* Walmart

Please? post?sites on projects idea's This just found on small lathes projects http://www.deansphotographica.com/machining/projects/projects.html