开云体育

Hi, Roberto, software packages from repositories are usually quite out of date. If you need to support CAT of newer or less popular model of trx, often it helps to build the software from source. 73

Richard, Is there power out in CW, keyed at the 991A ? David <vk4tux@...> wrote:

I avoided putting pictures in my original post but just to add some details... I've been on Fedora since version 12 and have been a packager for over 12 years so while I always try to accept the fact

On Tue, 11 Feb 2025 16:54:12 -0600 "Richard Shaw, KF5OIM via groups.io" <hobbes1069@...> wrote: It suggests that maybe an audio switch or amplitude setting for the Tx/Data modulation

Chances are, you are sending audio to the wrong USB speaker port. This is digital and we are sending SSB. If the radio isn't getting audio input, then you get zero power out - that is the nature of

Ok, I'm hoping something is not wrong with the radio but that is looking less and less likely. I have a Yaesu FT-991a that has been working FB for a few years. The other day I sat down at the shack to

I have an sBitx v3 that has essentially not modified, other that a dist-upgrade (It runs some Raspberry pi version of Debian). The full power is 25 W, and when I set the PA drive to 63%, I get 10 W

Tim, maybe I am not understanding the issue here. The very first thing you need to do is to find an RTTY signal and make it visible in your fldigi waterfall / passband. And you should be hearing it

Hi Dave, I am sorry I captured the wrong picture on the FSK one I kept adjusting the S/N number from dark red to light yellow and could only decode noise. ?I did widened the filter and that did not

Hi Tim, In your second screen shot I do not see any signal in the passband, but instead, I see a LOT of noise. Earlier you said I am not sure how you did this, but from this shot, there is no signal

Hi Ed et al, I've seen an issue where audio devices "go away" and one is left with only the dummy output. One can check in the audio mixer to see if this is the case. On various internet posts, this

[email protected]> wrote: I'm having a similar issue out of nowhere... TF-991a, never had an issue before but now I can't get any TX output. Change to my desktop speakers and I can hear the FT8

I will be following as I am having this problem with an FT710, full cat control and receive audio with decodes but no tx audio just tx PTT activating. Randy

Anyone have a clue?

Dave, On data mode for the RADIO with the same settings on FLDigi. ?You can see data being decoded When I switch to FSK, the decode stops the same setting on FLDigi.

I have a Chromebook Lenovo CT X636F.? Tried to use Crostini (crouton): can install FLDIGI and run it but, as stated by some online help, Linux software running in Crostini can only see "supported

Usually what happens when people try to do this, is that there is no one transmitting in the new passband when switching to FSK mode. And if there is, the FLDigi 'red lines' tuning indicator is not

Thanks David. I'll get something to you later today. 73. Dave G0WBX.

Confirmed here too. Many thanks. Dave G0WBX.

John, Yes it was one of the first things I checked. ?On Data mode it decoded but moving to FSK it stopped. Tim