开云体育

There are many devices described as SD readers.? Some also describe writing.? So... ...Are all SD readers also SD writers?

What distro? Was the distro upgraded? Was QSSTV built against the libs in your current distro or it an old version from the last distro revision that is having trouble with the new libs? Is this some

QSSTV is now running. It sometimes receives partial images. It stops part way through the transmission and stops running. Other times it does not recognize a strong signal. Will not key

WTheyS 100% bloatware jolly interfaces are nice but could tip the specification outside small computers like the Pi. Dave G0CER [email protected]> wrote:

I used to use QSSTV and YONIQ but they quit working. I will try again. Perhaps something got lost when I upgraded my OS. Thanks. I will let you know what happens.

I agree 100% !!! Please don't change anything, it's SO GOOD and simple! :) Any change in UX is always upsetting users. (I was upset about the settings and configuration menu changes, now everything is

Thanks David, see inline. I've fixed my problem as after Bob, VK2YQA's advice. 73 Phil GM3ZZA ________________________________ Sent: 22 January 2025 5:01 PM To: [email protected] <[email protected]>

Great info!? Guess I have a little studying to do...Thanks much! 73 Keith

Hi Keith The way out of the errant Thor idle is probably to change the modem to "NULL" just after the PUSH command and use POP to bring it back. eg <PUSH> <TXRSID:t> <!MODEM:NULL> <GOFREQ:1477>

Thanks Bob, Your other recommendation seems to have fixed the problem, so I don't have to go down this path (yet). 73 Phil GM3ZZA ________________________________ Sent: 22 January 2025 5:00 PM To:

Thanks Bob, Clearing out the config file fixed it for me. Now just need to wait until the bands reopen tomorrow before seeing if I can actually receive signals. I know what hash collision meant but

Thanks much, Bob!? This works better but between the TUNE and RX commands, the mode still shifts from a pure (TUNE) tone to one characteristic of the mode fldigi was currently in. I.e., if I'm in

Absolutely agree, too. sp3rat W dniu 22.01.2025 o?19:04, Dave, G?WBX via groups.io pisze: -- Pomó? Wojtusiowi w walce z autyzmem: KRS 0000252666. Cel szczegó?owy: Wojciech Karg

Hi Keith I'd expect the last two commands need to be prefixed @ so they run post TX>RX. TXRSID toggle I think will be TXRSID:t You can restrict the PUSH to just the freq if you like. It (and other

Hi, Solar from today 22-01-2025 @ 11:00 UTC No NOAA recordings. Attached the Nancay recordings. Huub Breda The Netherlands Locator: JO21jn

The Keystone ARC in York, PA, runs a SSTV repeater on 28.680. It requires a 1477 Hz tone for 1.5 seconds that (should) trigger the repeater to send a CW-ID.? Then, one can send a SSTV image to be

Absolutely agree. Gayland KG7GCF [email protected]> wrote:

Indeed. One of the main attractions of Fldigi (and companions) is the simple and clean UI. As a result everything works well on lower capacity hardware, and works very well indeed. Even on a little

Look for QSSTV on Github. (Just googling it found it for me.) Install all the needed dependencies (copy paste the example command line incantation. If anything already exists, it'll either get updated

I know it's not Linux-based, but since SSTV seems to be of interest here,? I can't help but pass along this link to a very cool new project from my friend Jon Dawson - a standalone SSTV