开云体育

Indeed. For some reason, they all got to be called 'DB', perhaps because the 25-contact size shell was so widely used. And before the high-density range was introduced, the pin-count and shell-size

Oops; I actually lied. The SHELL size is indicated by the character after the D; turns out that there are multiple pin densities that can be fitted to each shell size. Donald.

D-submini connectors use the character after the "D" to indicate pin count: Donald.

they are all in the connector library under D-Sub Andy 14:46:40 +0100 "John Woodgate" <jmw@...> wrote:

Ah! I found it. I didn't expect the unpopular but correct DA prefix to be used. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

Is there anywhere a symbol for the DB15 15-contact connector? I know that I could make one, but its geometry is not simple. -- Signature OOO - Own Opinions Only Best wishes John Woodgate, Rayleigh,

Thanks very much, Andy. That icon is called 'Edit symbol fields' in version 8.0.2, which is a correct name but misleading. It is in fact a BOM, formatted the way I proposed in my bleat about the

I'm still using V 6 as I've been out of action with a long stay in hospital so I've not upgraded for quite a while. The basic problem is that I don't know my left from right :-) 4th Icon from the

Sorry to be persistent, Andy, but I am using version 8.0.2 and I can't find that icon on the Schematic toolbar. It goes Save, Schematic set-up, Page settings, Print, Plot, Paste... I think that the

Top toobar at theb left hand end, looks like a spreadsheet icon Tooltip is "Bulk edit fields of all symbols in schematic" As for the BOM, well that's why BOM / stock control systems cost thousands.

That's most interesting John.? If have time tomorrow I'll give this a try.? Off to Dayton Tuesday for the week. Hamvention. Peter ve3poa

Hey, the dots have suddenly appeared. But also, some spurious short wires have appeared, coming from dots and going nowhere. The imported symbols are smaller than the native KiCad symbols and the

Thanks, but I do not know what 'table layout view' is. How do I find it? I notice that the BOM generator is buggy. It doesn't cope correctly with several components having the same value and

You should be able to do that on the table layout view Just cut and past as required in the footprint field. Andy "John Woodgate" <jmw@...> wrote:

Yes, I did, but the connections and crossings seem to be preserved. Now I wish that there was a way to assigning the same footprint to all the resistors in one operation, instead of 61 separate

John, Did you find the same thing as I fid?? Connection dots did not import jnto KiCad? Peter

No need to reply: I found out how to do it. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

Thank you. Would you please tell me how you did that, because I can't find? a way that works. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

I did? import a LTspice schematic but not sure if it was v8.02 or not. It seemed to work ok except the connection dots did not show up in the schematic.? ?KiCad did know there was a connection.?