On 06/06/2012 22:46, Peter Bennett wrote:
2. When you place a right-angle bend in a track, PCBNew insists on
replacing the 90 degree corner with a short 45 degree track segment (it
may be possible to disable this action, but I couldn't find a way).
It's easy to overcome this, but a little tricky to describe. Where you want the 90 degree bend just click twice (NB: click twice is does not mean double-click) and set off in the direction you want the track to take. When you click at the next node the track will be laid bent through 90 degrees as required. Note that in general this is not good practice, but sometimes it needs to be done.
Regards,
Robert.
--
() Plain text email - safe, readable, inclusive.
/\
