开云体育

as everybody and heir granny moves 1khz up, why the need for a macro? Your split shpuld be determined by the width and direction of the pile up? No?? Tom GM4FDM -- I thought growing old would take

Thanks Bob it wasn't in the text file must try harder 73 Ian G4GIR

If you want to add mode/submode d'jour, it must be added to the ADIFModes.txt file, it must be added to the BandPlan, and it must be checked as a digital mode (if you want it included in the Digital

Found it. Thanks to all, Panos and John G7SSE, I remember adding SUBmode WSQCall (because I had worked it on LF), Deleted that from the band map and all is now fine. Checked the latest ADIF release

... and the BandPlan is a text file called MyBandPlan.db 73.

All your colors/fonts/etc. is inthe INI files. As far as logbooks are concerned, KISS and make an ADIF backup. 73.

Hi Bob I have just carried out a rebuild of the log, re-calculation and still no QSO'S shown in the Generic QSO window. Down loaded the full version. and installed it. Run the re-install and still no

Blush blush blush Op 24-7-2021 om 15:40 schreef Bob:

Thanks Bill. 73 Ian

The rotator debug window is empty Op 24-7-2021 om 15:40 schreef Bob:

Ian - Yes, works for all awards including IOTA. Panos - I did add Q65 a few months ago, but since I reloaded everything it is no longer there.? You might be on to something! I'll try adding Q65 to

What do you see on the rotor debug window? Is there a Rotator seected (are you on a band with a rotator)? What is the text in the rotator pane in the lower status bar? What is the tooltip of the

Bob OK about the first one. I have to install Logsync. But about the rotator there is no error message, Com 3 is figured. Op 24-7-2021 om 15:21 schreef Bob: --

Jan, the error 53 says the utility program you are trying to open when Logger32 starts is not there. Click TOOLS | UTILITY PROGRAM SETUP. You need to install all the utilities you open when Logger32

After a severe crash I had to install Windows and all other programs again. Sofar I only installed my most important program : Logger4 Now when I start Logger I see this message: And another thing is

... or, you can send your logbook to Club Log (in chunks of 10K QSOs) and they will correct ant DXCC/CQZ problems automatically (just a few seconds for each chunk). Click SETUP | UPDATES | VALIDATE

I have carried out further investigations into this problem (still not fixed it though). There are 3 common denominators in all of the 6 Configurations. Involving DXCC, DXCC CHALLENGE and IOTA, all

The Club Log exceptions file also says this: So, if you enter SV2RSG in the Logger32 logbook entry window now, it will show as 'Not accepted for DXCC'. If you were lucky enough to contact SV2RSG/A in

Hi? Bill. I had a similar problem in past when I have added a new mode (Q65). Did you did something like that recently? 73

Bill, Could you check all the award options to make sure you get QSO's showing in the Generic QSO window when clicking on a slot please. Assuming you have IOTA references stored etc? Thanks 73 Ian