开云体育

Jan, the error 53 says the utility program you are trying to open when Logger32 starts is not there. Click TOOLS | UTILITY PROGRAM SETUP. You need to install all the utilities you open when Logger32

After a severe crash I had to install Windows and all other programs again. Sofar I only installed my most important program : Logger4 Now when I start Logger I see this message: And another thing is

... or, you can send your logbook to Club Log (in chunks of 10K QSOs) and they will correct ant DXCC/CQZ problems automatically (just a few seconds for each chunk). Click SETUP | UPDATES | VALIDATE

I have carried out further investigations into this problem (still not fixed it though). There are 3 common denominators in all of the 6 Configurations. Involving DXCC, DXCC CHALLENGE and IOTA, all

The Club Log exceptions file also says this: So, if you enter SV2RSG in the Logger32 logbook entry window now, it will show as 'Not accepted for DXCC'. If you were lucky enough to contact SV2RSG/A in

Hi? Bill. I had a similar problem in past when I have added a new mode (Q65). Did you did something like that recently? 73

Bill, Could you check all the award options to make sure you get QSO's showing in the Generic QSO window when clicking on a slot please. Assuming you have IOTA references stored etc? Thanks 73 Ian

Edwin since the QSO was on July 24 which is after the July 23 Clublog file, you may just need to wait for an updated Clublog file. -- Gerald, VE1DT

Bill, It is my great pleasure to present you with this week’s L32 Serendipitous Success Award. Please would you choose my NZ Lotto numbers for this evening’s $15m draw? 73 Gary ZL2iFB Sent: 24

Rebuilt the logbook and did a recalc - still no entries when I click on an award grid.? Also tried a fresh .INI, but no luck. So I thought I would delete all the award files and recalc, but I went

Hi Karl, The screenshot of “Internet Properties” was from my Windows 8.1 system. In Windows 10, the “Internet Properties” configuration function is very similar, almost identical in fact. The

Hi to all, I have L32 v4.0.269, the ClubLog Exception is updated but L32 shows QSO with SV2RSG/A as *Not accepted for DXCC*. As you can see at

Now another question..... When using the macro $QSY #Split+01q#$ I get a response from Logger32 "The BandPlan has no entries that match a frequency of 18099.0 MHz" - which is true if it really did

Thank you Aki that cured it Very grateful for everyone's help. Now another question..... When using the macro $QSY #Split+01q#$ I get a response from Logger32 "The BandPlan has no entries that match a

Vince Check this, Read VFO-B Macro. 73 de aki JA1NLX

Dave, Again, thanks but no joy. I've set it up both as a 7300 or a 7800 but that doesn't seem to make a difference either. V

Vince, apologies, I copied the image from the Help Guide. My actual setting is SO2V, like your self. 73 John - G7SSE

In the radio setup try set DTR high. I thaink that fixes it. My 7300 is in the pickup so I wont get out to the garage till tomorrow. Dave N8DC

John, Thank you but that doesn't seem to work. "Split Operation" is still flashing away to itself. I'm running SO2V and I see you are set up for SO2R, I don't know if that makes a difference When the

I received this message at 13:00 local time. Then I received a message at 13:06 referring you having done a recalc and it made no difference ... Unless it takes 6 minutes or less for you to do a