1) If there was a radio connected to the slave port, and the slave polling option was configured, the slave frequency and slave mode fields would be populated.
?
2) If there was something connected to the slave port, the data you see in the debug window would be sent. Yes, there is code (probably untested) that takes frequency changes from JTDX UDP messages and sends then to the slave port (easy enough to test).
?
Or something like that. SeventyThree(s.
?
?
On 03/16/2025 5:36 AM EDT Alec SP2EWQ via groups.io <aleksander.otulak@...> wrote:
?
?
?
Hi,
?
I need Your expertise on the Slave port set-up,?because I feel something I may have set incorrectly.?
I have not yet connected?the amplifier to?the port, so its response to the commands is still unknown to me.
?
The Slave port set-up is as follows:
?
It resulted in following the frequency changes of VFO A:
?
and it is how the radio port has been configured:
?
My questions:
?
1. Should?
?show the frequency?data?
2. Is there a way to forward frequency data to the slave port
? ? while using WSJT-x connected to Logger32 via the UDP port and the Radio-port closed,
? ? please?
?
Best regards,
Alec
?
?
?
------ Wiadomo?? oryginalna ------
Data 15.03.2025 21:32:55
Temat Re[2]: [hamlogger] COMport: Band tracking data
?
?
Big thanks, Bob!
?
Best regards,
Alec
?
?
?
------ Wiadomo?? oryginalna ------
Data 15.03.2025 18:24:19
Temat Re: [hamlogger] COMport: Band tracking data
?
... or, if your amplifier doesn't/cant read CAT frequency commands, then you could use the serial port antenna switch which allows you to program whatever serial data your amplifier needs. SeventyThree(s).
On 03/15/2025 12:32 PM EDT n5kd <n5kd@...> wrote:
?
?
If your amplifier can read RS232 commands, then Logger32 has a slave port that can pass the CAT commands out on another COM port.?
Search for ¡°slave¡± in the help file.
73¡¯ Pete, N(KD.?
Sent from my mobile
On Mar 15, 2025, at 11:26, Alec SP2EWQ via groups.io <aleksander.otulak@...> wrote:
?
?
Hi,
?
I had been often asked about that,?and now,?
I am facing the question myself:
?
How to get the band data out from Logger32, so that it can be used for an amplifier
to follow the band the Radio/Logger32 is on?
?
Naturally, getting that directly from the radio is not possible?as there is no such an option,?
so the only way to make it is using a PC's COMport.
?
Perhaps there is some kind of bridge-software or so,
please?
?
Best regards,
Alec SP2EWQ
?
?
?
?
?
