开云体育

I guess I should consider myself fortunate. I got a gallon of silicon oil from work. It is use to keep the HV electrodes cool that make ozone for our DI water system/PW500. I put it in my old Heathkit

I have never seen a price list for the spare load resistors for Bird Loads. I presume that the prices are horrendous. When I inquired about overseas shipping of the Bird Load Silicone oil, it was

Oh Man! I am looking very forward to this! I want one of these! Seems as if I am always either a day late or dollar short. Definately keep up the good work and keep the community posted. Can't wait to

*Clean Alpha 87A Full Legal Limit + * Located in Southern California, Inland Empire. Avail. for local demonstration. Pair of Genuine USA Eimac 3cx800a7's Unlocked for 12 meter and 10 meter operation.

if pushed hard on 80 and 160.. can and do arc over on the band switch and the wire that runs down thru the switch.? I have had to clean mine..

Never heard of a problem with the band switch....there are 9 people, in a group of u, that chat every morning on 75 and they/we all have 82's. This a new 'issue' to me. In any case, never had an issue

Best check the band switch prior to a sale, they are pretty much unobtanium at a realistic price. As far as I know you need to order direct from manufacturer of switch, they have a 5k minimum order

I am located in Reno, Nevada. I say this right off the bat as this amplifier I am offering for sale, is too big for me to ship, so…… I have a 6 year old AL-82 legal limit amplifier to sell. I am

Hmm... I've attached some pix.? The one thing that doesn't fit is that the silver fitting on the wide end/front panel fits that 3/4" copper pipe perfectly; it will not fit any known (to me) dimension

Hold on a sec Scott. If the resistor measures 2.7:1 out of oil it isn't going to improve when in oil. The mention of a copper center conductor makes me wonder if that was added or does it look

I've been futzing with the Termaline. Inside there is about a 14" long copper 'shell' that is the 'exponentially tapered line section'.? Inside the shell (which is the coaxial shield) is a 3/4"

Protection board install. Plate and also grid overcurrent protection. Both grid and plate meters have also been re-scaled to the new values required. https://www.youtube.com/watch?v=zfyRut3DgjI

Thanks for the help everyone. Turns out there was a coil slug in the 20m coil. I was able to adjust it and now full power out on 20m. 73; Steve NY3A

Do all the coils look the same or is the 20 meter coil different? Bob W4JFA [email protected]> wrote:

There ?are no??adjustable caps, only the slugs are adjustable. ?If you don’t feel the slug someone could have ran it all the way in and if fell out of the slug. ? Sent from the all new AOL app

I have an older AL-82 that works fine except the input SWR is right around 2:1 on 20m and it's just high enough to cause the K3 that I am driving it with to start to foldback so that the output power

Maybe you can make a short jumper with some L or C (which ever's needed) to tune out the reactance at those UHF freqs? Bob W4JFA [email protected]> wrote:

In? lieu of a DL, what else that works is.....? 160m at high noon......and 10m at midnight. On 40m, just find some SW AM broadcast station, and tune all you want.

I gave up the oil loads years ago. Also supposed to use a special silicone oil which is not cheap. I use air cooled loads, this one came out of the att ship to shore site in ocean gate New Jersey.