开云体育

Guffaw!! R L Measures, AG6K, 805.386.3734 r@..., , rlm@..., www.somis.org

More taurine feces, John, Cheerz R L Measures, AG6K, 805.386.3734 r@..., , rlm@..., www.somis.org

Gent's Some poor fellow on the 'other' amp reflector smoked the 25 ohm 25 watt wire wound glitch R on his Henry 3K . What was not mentioned was that Henry installs the glitch R in the B-..... NOT the

wrote: used, What's up? ########### Congrat's... u just found ur 1st mistake. If this is orr's latest blue book..... which page is it on ??? I found 38 mistakes in it so far.. mainly typo's.... have

Transceivers , the between them. ### You double the spacing between any two plates... and C drops to just 1/4 of the original. [ V rating doubles]. ### conversely... u reduce the spacing by 1/2 the

wrote: <zerobeat40@> envelope varies from zero to full pep. So, if your two tones are, say, 3Hz apart, then the power supply is having to feed out current that varies at a 3Hz rate. Not a prob with a

Hey Jim, No, the book is ARRL's VHF/UHF Handbook. The formula is correct, as it is found elsewhere, including Orr's book (p 2-6, 23rd Edition). He includes the term for inclusion of a dielectric. He

--- In ham_amplifiers@..., "pentalab" <jim.thomson@...> wrote: > > --- In ham_amplifiers@..., "zerobeat40" <zerobeat40@> > wrote: > > ###> The 2 tone test is flawed, and isn't

I wrote: In the VHF/UHF Handbook, chapter Receivers, Transmitters And Transceivers , section, 'Tuned Circuits'; the author writes: "If discs are used, the capacitance varies in a very non-linear

In the VHF/UHF Handbook, chapter Receivers, Transmitters And Transceivers , section, 'Tuned Circuits'; the author writes: "If discs are used, the capacitance varies in a very non-linear manner with

--- In ham_amplifiers@..., "zerobeat40" <zerobeat40@...> wrote: ###> The 2 tone test is flawed, and isn't used anymore in the > > commercial world. By juggling the spacing of the 2 x

wrote: mis- seem to it grid the #### well, I just tried it on one of my 3 x L4B's.... I get ZERO grid current with no drive applied.... whether both 3-500Z's installed... or jus

Both. but not with a uA meter.

Did you measure it or are you still depending on the data sheet? Did you measure that, or are you still consulting the road map which may or may not agree with the roads?

Probably pico-A with 5v of reverse bias.

Not with several volts negative on the grid with respect to the cathode.

That's too bad.. it's elitist... I can remove any email (spammer) by just administering the list. His excuse of stopping spammers is bogus... There was a ALPHA list somewhere else too...maybe it went

Message 863 is not there as you stated... I have no clue where it went.. And there is NO censoreing on this list. Just play nice. pentalab wrote: -- Bob Vmoa chat list ->

Microamps is still not zero...Rich is claiming zero. I think I measured fractional milliamps - e.g. hundreds of microamps. May have to re-run the exp. The 3-500Z is not a tube I have a lot of