开云体育

MFJ does sell a stand alone dip meter that's decent as I have one of them. MFJ doesn't manufacture this meter either, they have them branded by an asian manufacturer. It's the same dip meter as the

dip least

Hsu, In reality, you can't compute the power output the transformer is capable of that way. Bill Orr done a carry over from the ARRL Handbook, or it was vice versa. The central core area in square

Hi , Could someone can tell me how much output power of TL922's HV transformer? I have an Bill Orr's Radio handbook, there is some curves ,in a chart, transformer weght in pound VS amplifier power

### why doesn't somebody offer an amp in kit form these days ??? That would be the ticket. The end user would have a better idea how to repair it... since he built it in the 1st place ??? ** Hmm,

Sorry, They do say what the form was changed to, I didn't see it the first read. It now is made with a glass-based phenolic tubular core. That would be similar to acting like micarta I would think.

All, Below is the link to the Oren Elliott website and the page with the roller inductors. It doesn't say what the form material is, just that it's "newly redesigned".

wrote: Not necessarily. MFJ could have blundered on the specs when ordering, or ignored some rated specs. I do know that Oren Elliott changed the form though, to which type I can't remember. You might

wrote: the

he worthless No, I meant I wouldn't doubt that he would have said this to Jim. accurate

one resistor per cap set up] and fired up the supply with a small variac ?? sucker exploded in the cal lab. 2500 > UF @ 450 V lytics don't got off like firecracker's someday ?? Panasonic MOF resistors

wrote: accurate Just tuning

ORIGINAL MESSAGE: wrote: ------------ REPLY FOLLOWS ------------ One needs to be careful with this. The typical single-tube or single-transistor dip meter can be pulled considerably off the true

Well, by some means Yahoo removed the text I wrote after my "Read this:" statement and before my sign. What I suggested to DJ7SW was to read the very bottom of the message, where there are

The 3-500Zs would be the buffer amplifier, and the 8160 would be the final amplifier. With the latter, as you realized, since the grid is grounded by its socket, a grid fusing device would have to go