开云体育

All- I gave the amplifier a try tonight at very low drive, slowly working my way up to legal limit to ensure the meter did not peg to the right due to an incorrect resistor value. Everything seems

All- The PDF file here works for me. I have seen this manual before. It has no information on the ALO/metering board. Yes, there are two meters in the schematic, but my LK800a does not have the same

Mark- The link to the LK800 manual didn't work here, error says page no longer exists. Can you check to make sure it's displayed correctly in your post- some of us would like to obtain that manual.

Does this work? Bama Manual Archive <https://bama.edebris.com/manuals/ampsuply/lk800> Bob W4JFA [email protected]> wrote:

No, other than the one you showed which I already had.

All- I have an Amp Supply Company LK800A amplifier that puts out full power.? However, I noticed recently that it shows no grid current reading when transmitting on multiple bands.? This is odd

https://www.ebay.com/itm/176326971384?_trkparms=amclksrc%3DITM%26aid%3D1110006%26algo%3DHOMESPLICE.SIM%26ao%3D1%26asc%3D277109%2C276751%26meid%3D0fb69d5d1e604449b0612f85bf7e037e%26pid%3D101196%26rk%3D

Its you Joe. They work for me C ________________________________ Sent: Sunday, November 24, 2024 10:34 AM To: [email protected] <[email protected]> Subject: Re: [ham-amplifiers] Smoker

Those links you posted are inop. You might want to just insert those images into you post or attach them to your post. Joe - W7RKN

https://brillman.com/product/7mm-packard-440-ac-delco-spark-plug-wire W4DNR

Years ago I built a supply for a L4B amp. Someone on Ebay was selling the cables that Drake used. It has control wires plus the high voltage cable in one sheath. Mike

Dear Mark, Here is a picture of the HV cable I use in most all of my amplifier build projects, mostly for the internal, point-to-point Anode circuitry. The Specs are: SUPRENANT CABLE CORPORATION #20

Using spark plug wire sounds clever but any spec I found for it shows "spiral wound" or "copper alloy" conductors rated in ohms per foot.? So even seeming "solid core" wires are intentionally

Yes. I had experimented with some liquid wrench on an acid brush and it seemed to work great on the wire bundles. But the "Fan-Monia" solution seems to do almost the same result. I will post some more

Getting the caps clean will be easy compared to cleaning the wiring.

I got the front cntrol panel all done, getting into the PS area now...pretty bad. https://ibb.co/bQnsj7T https://ibb.co/fMPttFc https://ibb.co/8YNtQYN In the PA compartment I see the bread slicers

I believe Tim is the president not the owner of DX Engineering.

Belden does make an 8 mm silicone solid wire spark plug wire.? You can buy the wire in bulk.? It's probaly the same stuff that Summit is selling.? For those that don't know, Summit and DX eng. are

I have substituted neon light hv wire ( inside a conduit ) for a 12KV@ 3Amps feed on a Continental FM transmitter. It's lasted 12 years so far. W4DNR

Solid spark plug wires are not resistive wires. You have a good point about being stiff. I now remember buying some bulk plug wires that were stranded, not resistive wire. I now remember making a set