开云体育

Here is Part 8. The vac tune cap is installed vertically. The vac load cap is also installed vertically. And both have right angle drives. The massive model 90 bandswitch, made by multi-tech

No, but I get all the fame!

No, but I get all the fame! Mike VK2AMF

Hi Ron, I emailed you directly asking the price of the transformer. ? I don't know if you received it. My email is good on QRZ.com.??? ....Bill K3HZP

What do you guys think about the correction kit sold for AL-80B? al80b-al572-al800-al800h-correction-kit ( https://www.ctrengineeringinc.com/al80b-al572-al800-al800h-correction-kit/ ) 73, Tony

You’re not the drummer in Fleetwood Mac, are you Mick ?? John VK6JX From: [email protected] <[email protected]> On Behalf Of mfle2001 Sent: Tuesday, December 12, 2023 6:12 PM To:

I ordered a pair from Penta Labs a year or so ago, very reasonable price with shipping to VK and amazingly well packed, so far so good in my TL922. Mike VK2AMF.

Bob, 45-50 watts in for 350-400 out 73 Nick KC0YKO ________________________________ Sent: Monday, December 11, 2023 11:45 AM To: [email protected] <[email protected]> Subject: Re:

#8 brass washer over the terminal. Sent from the all new AOL app for iOS

It's been over 40 years ago I believe, but I think the final solution was to wrap a solid wire several turns around the contact where the wire was soldered.? There were sharp points that made it

I was told, years ago, after experiencing the same malady in a Yeasu 2100 by a more experienced ham (sic) to never change bands with the amplifier on. Seemed sorta silly to me. I heard later on in my

So, did they fix the problem, and if so, how?? Heftier contacts or bandswitch? 73, Steve K0XP

I had one of the first AL-80s quite a while ago.? It was very good at vaporizing one of the bandswitch contacts when operating on 160.

Jim, I have one of these amps. With low drive from the exciter, the "load" will often end up all the way left/meshed. That's why I asked the op that. Bob W4JFA

I emailed you directly yesterday regarding the parts I am looking for. Did you get it? Sent: Sunday, December 10, 2023 12:10 AM To: [email protected] Subject: Re: [ham-amplifiers] Ten-Tec

It appears the padder(s) are not being switched in on 40-80-160m.? BUT u have the issue on all bands.? It's as though the load cap isn't even in the circuit, or lousy tank coil coil connections.

Here is part 7. The 160-15m manually tuned, tuned input is now complete. And yes, the input swr is dead flat across each band . https://www.youtube.com/watch?v=ev-648v_G0I

Here is part 6, where the manually tuned, tuned input is almost complete. https://www.youtube.com/watch?v=_V8om_cRk-o

Here is part 5, with the manually tuned, tuned input + input RJ1A vac relay, input coax etc. https://www.youtube.com/watch?v=sk-nmCjWa7I

This reflector allows photos; it might help if you showed a photo of the wafer you need, as well as the spacing between mounting holes and the total number of positions. But I wonder if MFJ doesn't