开云体育

pentalab wrote: <snip> I had this same problem... it insisted that since I was in the USA there was nothing there for me. That was using my favorite browser, Firefox. I opened the dreaded Internet

Kathy&#92;(K5MWH&#92;)" <w5uc@...> wrote: ### I can't get into Svetlana's site either..... have not been able to.... for a couple of yrs at least. I printed out some of their stuff but not what u

Bob -- It would be interesting to compare this with the AMPS total, but that information has been kept secret ever since someone who got booted off of AMPS by the moderator/censor, downloaded the

Passed the 100 total members mark this week. de KR4DA Bob

Good Evening All: I am looking for information about converting the HA-10 Warrior for 160 meters. There is a Svetlana page with the info on it but I am told that we in the US are presently unable to

Silicone rubber is used to insulate HV wiring.

I'm repairing a Bird 5000H element (2-30 MHz 5 KW) and the resistor in the slug appears to be wrong. What is the nominal resistor value for this element? TIA

Does this mean there is no problem with routing the silicone cooling lines out of the HV end of the line? -John, N9RF

060920@...> wrote: in a doubler. A doubler's caps only gets charged 60 x per opposite half cycles so half the stack is always being charged. ### A FWDoubler is nothing more than two 1/2 wave

pentalab wrote: <snip> <snip> true, but in the FWD, each half of the stack is charged on opposite half cycles so half the stack is always being charged. 73, Tony W4ZT

wrote: #### I'd call that 1/3.... NOT 1/6th. What if I give a 5 min disertation? or some contester calss 'cq' for 3 mins straight? ### The big kicker is gonna be CW. Dashes are gonna be at least 3 x

We have an EMI amplifier (IFI406) with 24 4cx250s in a TWA. one of them has a short between G1 and cathode. It comes and goes with heat and when it happens the plate supply shuts down. Anybody have an

ORIGINAL MESSAGE: wrote: ------------ REPLY FOLLOWS ------------ It really depends on one's manner of speaking and one's individual voice. Some people put relatively large pauses between words and

80-160 meter tankcoil on a large toroid? Rated output is approx. 6 kW Hi Dick, One idea is to use two or three number 10 or 12 gauge enamel side by side wound as a ribbon, connected in parallel. They

Am 27.09.2006 um 03:25 schrieb craxd: Nothing really lost. Using the "history" tab on the page shows who did what with it. You could paste your version again in there... Your text is still available.

What kind of (stranded) wire (or strap) can be used best to wind a 40-80-160 meter tankcoil on a large toroid? Rated output is approx. 6 kW Cheers, Dick PA3DUV

I have done some modifications to the shematic, so i have uploaded an revided shematic. I can't see the reason for floating the B-, to mesure the current i would just add an 0.1 ohm resistor between

The best way to measure a transformer gut temp is measure the winding resistance cold then hot and determine the real temperature rise by the copper constant. I think it is about .4%/degreeC. wa1gfz R

All, I hate to say that some dumb a$$ deleted almost everything I had written except some corrections about the windings. I'd about bet they were the one who wrote the screwed up stuff I had to

During an ahhhhhhhh, I see about 1/3 of A0 anode current. If one transmits half the time, that's a duty-cycle of 1/6.