开云体育

speaking of fuse clips. do any of you guys know where I can get some big clips for fixed vacuum caps like used in the BC610 padder cap. I need to add a padder to my antenna tuner for 160 meters. I

Am 30.10.2006 um 19:46 schrieb pentalab: ;-) Worth to remember when choosing to put them vertically. Just looked on the UK web site of Cooper Bussman and found a German distributor (a mere 100 km away

is While group I fuses. the 3,5 protect the HV- transformer any better than a circuit breaker in the primary. cheerz ### What about protecting everything else ???? Short the B+ to the chassis/

Forget the link to the datasheet: http://www.g8wrb.org/data/Eimac/YC156.pdf The only thing I have against the YC-156 is the noise...damn, they're loud, if you're wanting to run power and keep 'em

Last 8281 I bought brand new set me back about $1050, and I think I had to add a socket. And, the tube's pushing good and hard at 20k, while a trio of YC-156's is loafing at 30K. Remember, a YC-156 is

wrote: is While I 3,5 #### SSON [surplus sales of nebraska] has tons of Buss HV fuses. The HVU-3 is what I use. [rated at 3A @ 5 kv AC] These are 13/16" diam on the ends, and fit standard 3/4" fuse

Am 30.10.2006 um 12:02 schrieb R L Measures: Yes, but it might protect a few other parts of the PS... Thanks, Rich, for the heads up. 73, Frank DG1SBG

craxd wrote:

Hi again: Further digging into details of the SIBA web site revealed a search function: http://www.siba.de/search/qsearch.php?Lang=en Specifying a voltage of 6 kV gives a result for a 8 x 120 mm fuse

Hello, Frank == A HV fuse in the secondary does not protect the HV- transformer any better than a circuit breaker in the primary. cheerz R L Measures, AG6K, 805.386.3734 r@..., , rlm@...,

Hi all: I am about to finish my HV power supply. One thing missing still is an appropriate HV fuse to be put between C bank and glitch R. While closely examining the pictures in the photos section of

Larry, This bound to have been in the early 70's or so. I had a GTE/Philco 19" TV I took in as a trade in and I played it myself for about a year before I sold it. I can't remember if it was all solid

All, I finished coding the first portion of the long formula calculations in imperial measurements for the Maxwell Transformer Calc. When the results are compared to the short formula for 12 kilogauss

pentalab wrote: <snip> I will measure this tomorrow and report back the difference between the measured anode to grid capacitance unmounted and sub-mounted.

craxd wrote:

thoroughly the If I recall, I found some errors about calculating anode current, or the terms used with it in the ARRL Handbook. It was contradicted by the RCA Radiotron book. There was a discussion

IMExperiences, it takes c. 11g of force for c. 30-seconds to unbend the midpoint of a 3-500Z's filament helices far enough to straighten it following an intermittent VHF parasitic oscillation. Thus, I

Anecdotal sure-cures don't cut the parasitic mustard.

The League seems to be somewhat less than serious about thoroughly updating and improving the Handbook. Example: In 1994 I got a letter from the League asking me if I was interested in improving the

ORIGINAL MESSAGE: wrote: ------------ REPLY FOLLOWS ------------ I'm sure there will be a few guys who know how to repair a tube radio or TV but they will become a rare breed, much like people who can