开云体育

I see a CLRSCRN MODULE on the Sixpack 1.3 beta 3 Y-disk. Bob Bolch

Hi Tom Have a look round this?https://github.com/devhawala/mecaff The home of the brilliant EE editor etc.? Somewhere in there is the c source for low level diag58 stuff and 3270 datastream err...

Hi, again, Tom, The first thing to understand is that in VM, with CMS, the "console" when it is a 3270 operates in two "modes" -- a line-at-a-time mode where it is emulating a keyboard printer (3215)

Hi, Tom, I recall we had MTS LISP running under VM/CMS back in the late 1970s. The way it was done, someone wrote a small "layer" or "jacket" or "wrapper" for all of the MTS system calls, and that

HI Tom, I'm not a C guy but I have done some BASIC stuff in the old days.? I followed the directions but I'm getting a DMSACC113S 'T (19F) ' NOT ATTACHED followed by a DISK 'T' NOT ACCESSED.? I'm

I remember a VMFCLEAR module and another VMFCLR module. I do not remember what level of VM or if they were transient modules. Neither one would have been too large to get the text and load/genmod as

Thank you. I will investigate and see what I can do. Again, Thank You Tom c

Tom, You need to use a DIAG 58 call. There are no character sequences that clear the screen. I think the simplest solution is to create a “clrscrn” module that loads in the transient area and run

I am trying to figure out to perform a clear screen form a "GCC C" program.? I am using the wc3270 program on WIndows to talk to Hercules VM370.? I have tried several different hex codes with no

Thank you. I have viewed many and now looking for something in the area of my need. Cheers Tom c [email protected]> wrote:

Tom, Moshix has a couple of videos about VSAM/Cobol & VM/370. Chris -- <cjar1950@...>

Thank you. Don't know if any will work, but more reading and trying to understand. Thank You Tom c [email protected]> wrote:

Tom, It might not work for VM/CMS, but have you looked at http://www.jaymoseley.com/hercules/vsam_io/vscobol.htm ? Chris -- <cjar1950@...>

Trying to write a batch cobol program under cms.? I have read cms guide.? Wrote what I thought was a simple cobol program using VSAM, and compiled it. Well, many errors. Question: does anyone have

Thank you Martin for that clear explanation! Peter

Hello, I have had the same issue when adding DASD to a VM370 system at the 1.3 level. Prior to this a simple create of the DASD and adding it to the machine config file with a suitable device address

Hi Peter, thanks for your help. I have it working now in hercules.rc but will move to AUTOLOG1 as that seems more authentic. Yes, without AUTOCR it is not a good idea to do this in OPERATOR. I did not

Hi Rene, I have seen it suggested somewhere to put stuff to be done at startup in the PROFILE EXEC of OPERATOR but I can't recall where. This is not the correct thing to do. You should place your

Rene, If you add it to the Hercules config you shouldn’t need to vary it on, only attach it to system. You can put this in AUTOLOG1’s profile exec. That runs when the system comes up, Normally on

Hi Carlos, thank you. I was thinking to do the VARY ONLINE nnn and the ATTACH nnn TO SYSTEM AS VM50-X in the PROFILE EXEC of OPERATOR. But I noticed that disk 191 of OPERATOR was not formatted, and