开云体育

TFX 18210 mixer used as frequency detector

john23 All Messages By This Member #99196 Hello , I have the following component shown below which needs to be used as frequency detector. Is there some datasheet for this component? I could not find datasheet in google. /g/electronics101/photo/296358/3858703?p=Created%2C%2C%2C20%2C2%2C0%2C0
Andy All Messages By This Member #99203 The original Avantel is gone.? The current Avantel () is not related. ? Wikipedia says Axtel acquired Avantel.? Try contacting Axtel, at or . ? Google found a little bit of data about the TFX-18210, in a document from Artisan ().? I think it suggests that they (Artisan) make a functional equivalent to the TFX-18210.? If so, you might look to Artisan for more specifications. ? Andy ? ?
john23 All Messages By This Member #99213 Hello Tony,where is this document could you share a link ? Thanks. ? in a document from Artisan
Andy All Messages By This Member #99214 On Tue, Nov 26, 2024 at 12:21 AM, john23 wrote: Hello Tony,where is this document could you share a link ? By "Tony", did you mean "Andy"? ? Like I said, I googled "TFX-18210".? Then I scrolled down to this link: ? ? Andy ?
john23 All Messages By This Member #99238 Yes, Sorry Andy/ I have made of a system which is based on the article attached from this mixer I tuned the YIG to the resonance of the resonator, then i measured the output of the IF on a scope as shown below. When I tuned to ph2 pase shifter i see the "error voltage" level shanges which need to go back to the YIG "FM" port as shown below. Also i need to make sure that the signal going back to the YIG is something which the YIG could make changes so It will be sensitive to the signal. What is the process of making the PLL lock? Thanks. /g/electronics101/photo/296358/3858955?p=Created%2C%2C%2C20%2C2%2C0%2C0 /g/electronics101/photo/296358/3858956?p=Created%2C%2C%2C20%2C2%2C0%2C0 /g/electronics101/photo/296358/3858957?p=Created%2C%2C%2C20%2C2%2C0%2C0 ?

Previous Topic Next Topic