开云体育

<lcdpublishing@...> wrote: Looks to me like the MAX232N is a Texas Instruments part while the MAX232CPE is a Maxim part. At least that't the way I found the datasheets. No matter, both use 1.0 ufd

Yes, even I managed to make the software for a encoder of this type work, and that says something! Good thinking really that quadrature stuff... ST

<lcdpublishing@...> wrote: OK, the device has quadrature outputs. This produces 4 transitions between detents. The reason for quadrature is to provide an indication of the direction of rotation. On

Thanks guys, I will double check the data sheet again to see if I can "Get it". If not, I guess the next best thing is to drop it in a socket and give it a try. I have a working module setup right now

--- HARI CHARAN <sharicharan@...> wrote: Go for "Integrated Electronics" by Millman & Halkias. Best book in the subject. __________________________________________________________ Yahoo! India

most often this suffix is the package and temperature range. As long as it fits it should be fine. But beware, there were -R versions of ICs that were mirrored upside down! Ideally check the

Nope, I just know that the signal _will_ change and that it might be instructive to see how it changes... -- Member of the toughest, meanest, deadliest, most unrelenting -- and ablest -- form of life

Roy, I will do when I get the cable in that I plan on using for this. By chance, can you give me a hint as to what sort of good and bad things I should be looking for? Right now, my technique on the

This link should take you to the datasheet (I hope) http://www3.alps.co.jp/WebObjects/catalog.woa/PDF/E/Switch/Encoder/EC12 E/EC12E.PDF

Hi Guys, I have a number of MAX232 chips on hand. Some are marked MAX232cpe and some are marked MAX232n. I tried to gather up what the differences are from the datasheet, but all that did was confuse

<...>

A link to a datasheet would help... Richard

It does appear that 20 feet of cable will work for SPI. The length is approximate, but I think it is close to 20'. The speed at which I am communicating at though is a bit confusing based on the

HI Guys, Yesterday I was experimenting with my AVR software and working with the different controls I will have on my operator panel. I got everything working good in the test rig but found something

HI ROy, In reality, I would have been very surprised had it worked! When I was first working out some serial communications software about 20 years ago, I used all short cables and PC-PC for testing.

The biggest mistake newbies make is an unintentional lack of tact caused by excitement at having found a bunch of people who share their interest in electronics. How to avoid this and increase your

A bunch of wire on a spool is also going to have some inductance, there, much more so than just a wire run to somewhere... -- Member of the toughest, meanest, deadliest, most unrelenting -- and ablest

Crownhill in Malta used to advertise their Dashmaster as being able to deal with most West European makes of vehicles. It was expensive (about GBP500) and I don't know if they still sell it.