I like those circuits.
Installed a large contactor that way on my bench to switch everything on or off. When i get fed up with something i can punch the off button and it shuts down with a satisfying thump ;-)
ST
toggle quoted message
Show quoted text
On Thu, 27 Apr 2006 01:14:05 +0200, rtstofer <rstofer@...> wrote:
There are standards. The normal Start-Stop circuit begins with a
normally closed Stop switch from one power rail to the junction of a
normally open Start switch and one side of the holding contacts. The
other side of the holding contacts connects to the other side of the
Start switch (they are in parallel, the holding contacts hold the
Start state) and this junction connects to one side of the coil. The
other side of the coil goes to common or ground. You really don't
want to switch an emergency circuit with a ground connection. Any
short circuit can simulate a ground connection.
The point is, it takes a specific action (pressing the Start button)
to get power but even the loss of power will cause the Stop function
to work. And the system won't restart.
A not particularly useful schematic is in Figure 7-16 here
Richard