开云体育

Swing up tool holder files

#MISC #MODS #LATHES #file-notice

[email protected] Notification #1438 The following files have been uploaded to the Files area of the [email protected] group. /Swinging Tool holder External.pdf /Swinging Tool holder Internal.pdf By: John Lindo <bechetboat@...> Description: Swinging Tool Holder Ext and Int byJohn Lindo
CLevinski All Messages By This Member #1440 John, What is the purpose of the two "Optional Rods" shown in the "Swinging Tool Holder External.pdf" file? -- Regards, Charlie New Jersey, USA SATTINGER’S LAW: It works better if you plug it in. EDWARD'S LAW: It works even better if you turn it on.
John Lindo All Messages By This Member #1441 Good question. The?drawing shows a pin on the swinging?arm and in the block there is a accurately?positioned slot. It used to be the thrust stop when cutting left hand threads, IE The tool going away from the chuck, this?early design reduced the bending forces being applied on the bearing pin. This was my first approach before I modified to add on the thrust plate. Now the pin/ slot are optional or use this method and not?use?the thrust plate. You do not need both designs.? I left?it in on my original drawings, also this pin is visible in some of the recent photos sent to the forum. Thanks for your interest. John toggle quoted message Show quoted text On Thu, 8 Apr 2021 at 14:56, CLevinski <clevinski@...> wrote: John, What is the purpose of the two "Optional Rods" shown in the "Swinging Tool Holder External.pdf" file? -- Regards, Charlie New Jersey, USA SATTINGER’S LAW: It works better if you plug it in. EDWARD'S LAW: It works even better if you turn it on. -- John
John Lindo All Messages By This Member #1443 ---------- Forwarded message --------- From: John Lindo <bechetboat@...> Date: Thu, 8 Apr 2021 at 18:31 Subject: Re: [digitalhobbyist] Swing up tool holder files #MISC #MODS #LATHES #file-notice To: <[email protected]> Good question. Charlie The?drawing shows a pin on the swinging?arm and in the block there is a accurately?positioned slot. It used to be the thrust stop when cutting left hand threads, IE The tool going away from the chuck, this?early design reduced the bending forces being applied on the bearing pin. This was my first approach before I modified to add on the thrust plate. Now the pin/ slot are optional or use this method and not?use?the thrust plate. You do not need both designs.? I left?it in on my original drawings, also this pin is visible in some of the recent photos sent to the forum. Thanks for your interest. John toggle quoted message Show quoted text On Thu, 8 Apr 2021 at 14:56, CLevinski <clevinski@...> wrote: John, What is the purpose of the two "Optional Rods" shown in the "Swinging Tool Holder External.pdf" file? -- Regards, Charlie New Jersey, USA SATTINGER’S LAW: It works better if you plug it in. EDWARD'S LAW: It works even better if you turn it on. -- John

Previous Topic Next Topic