¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. YardbirdTrains
  2. Topics

Replacing a brass frame on a Bowser H9s ??

 

Henry,

Are the holes close, or way off? If close, a small round needle file can elongate the hole in question for a bit less effort (arguably) than making a new cover.

I've had a couple of Bowser brass cover plates (my H9s models come to mind) where the holes were slightly off from where they should have been....perhaps an error in the stamping/cutting process?

Doug Kisala

On Wednesday, September 12, 2018, 9:09:10 AM PDT, huligin62@... [yardbirdtrains] <yardbirdtrains@...> wrote:


?

I may make my own cover ? The old brass one does not line up .. The cover hold down / truck purchase and the spring holder don't come close to fastening ! I'm looking for my Quarterer which should be next old faithful ????? As always ,? Henry
 

FYI , Bowser still has brass cover plates? for a buck ??? Henry
toptrain2100
 

So what happened Doug did you get it fixed or is it still awaiting parts.I have some parts for the H9.

Does this look like what you need.?

1 - 3 of 3