开云体育

Thanks, I realized that when I opened the ROM in my hex editor. Now to get some EPROMS and a writer & eraser!

Yes, you can. Did this some years ago on a friend's DX7 Mk.I with original firmware - put in his name instead of the Yamaha splash screen ;-) Please see attached pic - the green surrounded area(s) you

Many years ago I have translated similar ASCII codes to different languages in some ATARI ST programs this way, and it was successful. If there’s no checksum somewhere in the end of the BIN file, it

Hi there, I opened up the DX7 SER7 .bin file in a hex editor and was wondering, is it possible to change the splash screen text from WELCOME TO? DX7 SPECIAL EDITION to something else by editing the

no, you didn?t and i didn?t either…i wrote “raw power” in an attempt to describe my joy about the “in your face” quality of the tx816s sound, which i had just switched on again after a

I didn?t use the term "RAM power" in my post. Am 06.08.2021 um 11:20 schrieb hwk: -- Diese E-Mail wurde von Avast Antivirus-Software auf Viren geprüft. https://www.avast.com/antivirus

hi p. yes i am aware that i can?t get the same level of polyphony from a TG77 (or “raw power”, whatever that means :-) it was more of a question in principle. the manual says otherwise and my

My TG77 is actually not in use,- but isn?t it, MIDI PrgCh 0-63 select internal RAM voices and 64-127 select any inserted cardridge?s voices (or performances) ? Plz correct? me if I?m wrong ...

hello daniel, preliminary results: 1. the table of bank selects for direct program changes given in the manual on p. 175 seems to contain errors. my findings are: 117: ? 118: preset2 119: preset2 120:

thank you, daniel, (i was secretly hoping, you might have an answer :-) its a good start, i will experiment and report back (might take me a couple of days) all best hans

SY/TG77 has rather complicated way of selecting patches because those times Bank Select command was not yet standardized. Select Direct Program Change mode. Set Device Number to 1. Try these two

(maybe a weird question): on a TG77, is it possible to change the voices, which make up a multi “on the fly”, with e.g. program change or a sysex command? i tried to figure out from the

No, you misunderstood my post. That’s why citation marks were used. I was merely expressing the limitations of the attached charts. To be clear, the size of the DX7S tuning units are probably

There’s nothing like Fractional Tuning. Yamaha calls it Full Keyboard Tuning. Besides Octave Tuning DX11 can do Full Kbd Tuning as well as DX7 II D/FD, DX7s, TX802, TX81z, WT11, V2, V50 and some

There is a?railsback command in the Scala.? You should be able to apply that to any tuning, including 12EDO, and then export a sysex file that you can load into the DX7S. You can start here and

On Jul 2, 2021, at 4:51 PM, LarryS <vision1@...> wrote:

Check Scala application. Daniel Forró

I have a chart in a piano tuning book that shows stretch tuning. Well, maybe I do. It's buried somewhere. L.

Anyone know if there are microtunings out there on the web for standard things like stretch tunings and the different mean tone options? Sent from my HAL 9000 in transit to Jupiter

CP80 Service manual is here: https://elektrotanya.com/showresult?what=yamaha+cp80&kategoria=All&kat2=All <https://elektrotanya.com/showresult?what=yamaha+cp80&kategoria=All&kat2=All> Daniel Forró