开云体育

ctuckwell@... writes: There really are two separate considerations: 1. Will it "match"? 2. How efficiently is that length of wire RADIATING (or receiving) the signal on that frequency? I've

67 feet. va3cgt <ctuckwell@...> wrote:So what is a good wire lenght that will cover all bands? I have up to 100 feet of wire to work with. looking for 160 to 6 meters but 80 to 160 would be

So what is a good wire lenght that will cover all bands? I have up to 100 feet of wire to work with. looking for 160 to 6 meters but 80 to 160 would be fine.

Gidday all, I have uploaded some photos of my mobile setup. It may not be 100% conforming with pure antenna theory, but it works! Regards, Peter, VK4TGV.

Sure can, I use a 1:1 balun with about 100mm of wire connecting the ground and antenna terminals to the balun, then run about 2 metres of co-ax to a spring base with a helically wound HF whip mounted

yes, I just conected the loop to the two connectors. I asked Yaesu about using the tuner on balanced and unbalanced lines and they said it should be fine. It worked well except for the QSB which I

for

As with any antenna, Just try it. Let us know what happens. Oh, use low power to start. from

I just got back from using my FT-857D and FC-40 in N. Maine on a canoe trip. I used the FT-857D on battery (with a 14W solar pannel) and the FC-40 connected to a random wire (~30-33m) most of the time

I'm constantly in a state of confusion. ;-) I use an ATAS-120 with my FT-857D in my truck and am really happy with it. I know there are better screwdriver antennas but the ATAS-120 is simple to

I'm pretty new at this, been reading up what I can about tuners & stuff. I'm also a bit overwelmed by all the advertising about this tuner, that tuner, and I'm a little confused... Is there a

I GOT MY FC-20 WHEN I PURCHASED MY FT-847 AND IT HAS WORKED WELL ALL OF THE TIME. IT, OR THE FT847 DOES HAVE A COUPLE OF QUIRKS. IF I SHUT OFF/DISABLE THE TUNER WITH THE TUNE BUTTON ON THE 847 AND

Bought them in a local electronic store downtown Munich. ----------------------------- Hanno Vogels, DG8JZ eMail: Hanno@... WIRES. #7124D Echolink: #4904 phone: +49 8102 729600 fax: +49 8102

Where did you get the connectors? female, 15m / tested with the distance of [mailto:YaesuTuner@...] Im

Andy Feel fre to start discussion about the FC-20, I have been interested in that tuner in the past but never bought one.

THIS GROUP IS VERY INTERESTING, BUT DOES ANYONE KNOW IF THERE IS AN FC-20 GROUP? I CAN'T SEEM TO FIND ONE ON YAHOO. TNX!! 73 N1CJG ANDY

Friends, I did it! I bought a set of connectores Din 8 Mini male and female, 15m / ~50 feet 8-wire and soldered the extension cable myself. Now tested with the original cable plus the extension....and

Yaesu USA do have a replacement cable part no. T9101543A and sells for $34.81 plus tax and shipping. This is again 15ft if you cannot find the plugs yourself...........73s Roger G3YBO

Okay, thank you... will go downtown Munich and will try to get the 8pin connectores and will solder a new cable myself. Belkin answered my mail and confirmed that the suggested cables are no longer

Yes the pins are 1-1, 2-2,3-3 etc.............Roger