开云体育

Hello All, Before I shell out the $$$ for a SCU-17 or SignalLink I have a couple questions. When using the Data IN/OUT port on back of rig do you need to also wired in the PTT circuit shown on page 19

Hello Jim The Molex 39-03-6064 was a bust. The pitch is 6.7mm as the rig's pitch is 6.0mm I did manage to crimp the crap connector female pins with a .100" crimper and they now fit nicely in the stock

Hello Micky. I cheat.? I go to our local Hobby Town and get a piece of K&S brass tubing that just fits over the end of the male or female pin I want to remove and slide it down so it pushes the barbs

Hello Pat. I need the socket that mates with the power cord end (or same as socket on the back of the radio) so I can make an adapter cable to try and fix an Icom that uses a 4 pin Molex!? Not sure

Hello Sjoerd. That (AliExpress part) is the wrong end.? I need the one that mates to it.? I think (hope) the Molex 39-03-6064 you linked at Mouser is the one I need. Thank you. Jim Pruitt WA7DUY

If you think that is expensive, wait until you price the crimping tool! Micky K1XH Links: ------ [1] /g/YaesuFT847/message/896 [2] /mt/104208473/1045683 [3]

Hello Jim, Give me a few days as I placed an order with Mouser and opted for the gold plated contacts. Here are the manufacture part numbers. Housing 39-03-6064 (1 needed) Female pin? 02-09-5143(4

Hello Jim I just ran through this problem with an Icom and ordered a few connectors to only find out they were crap. Hopefully someone here will have some insight on some good ones. This is why I try

Or maybe order:

Hi Jim I found the connector on: www.molex.com part number: 39-03-6064 Best 73 Sjoerd PA3DOL

You could also try the rear panel connector for FT857 or FT897, seeing as they are the same item, and more likely to be available Andy

I will look it up for Yaesu may still stock ?Get BlueMail for Android ?

Can someone give me the Molex/Waldon part number for the power plug for the FT847 (and cord mounted socket for it if you know)?? I see places that sell the cable but nowhere do I find the part number

Using a self-built circuit based on VK4SN. 73 Jorge CT1EXR Em seg., 5 de fev. de 2024 às 17:22, Hal Dale <wb4aeg@...> escreveu: -- *** Help us to save energy & paper - do you need to print

Has anyone had experience with using the digirig module with the FT847?? Hal/WB4AEG

Set the level for good speech on mic gain then leave it there, pad down input level to no more than 5mV rms KR Andrew ?Get BlueMail for Android ?

I set the audio level to just barely cause the ALC to move when in transmit mode.? I set the power control on the radio to give me the desired watts out.? I use this same method for all of the

So for SSB modulation, the volume level is what sets the output power to a large extent. So both the power output setting on the radio and the volume setting on the computer interact. How do you

Peter, correct.? After that, I use the actual power control on the FT-847 to set my output power.

Peter, That is exactly what I do when I use my FT847 with JS8. Steve NA4SA