开云体育

The USA frequency settings may extend the 40m band, if not just live with the full extension and you will also get 60M 73 Andrew ?Get BlueMail for Android ?

Hi All. I bought some years ago FT847. Rig is ok and good condition. Some years ago at OH we got extension to 7 MHZ. Here is allowed now up to 7200 kHz, and rsdio can transmit up to 7100 kHz. I have

For what it's worth... I did what is shown in the video years ago, paralleling the contacts and adding a 0.01 uf cap. It's pretty easy as the front panel tips down. Never had a problem. And I do turn

I would suggest you do not just turn psu on, it will more than likely have a voltage surge on switch on. Disconnect positive from psu, turn on psu and then connect positive. I have plenty of switches

There is a whole thread about low VHF power it may not be the output transistor KR Andrew Sent: 21 June 2023 13:50 To: [email protected] Subject: Re: [YaesuFT847] FT-847 power switch HI Years ago I

HI Years ago I had the same problem too. Sooner or later it happens to everyone, it depends on how you use the radio to know if "BEFORE" OR "AFTER"... The first time I shorted the contacts with the

Hi all, Sorry it's in Portuguese but it's good solution too: https://www.youtube.com/watch?v=MoLWswLFwVA Maybe subtitles could help 73,

Mine was modified years ago when replacing the switch. Paralleled the contacts so both sets of contacts are used instead of just on side of the double pole switch. 73

As you have to strip down the whole front panel, I would leave it in the on position if that is possible, I would only strip down, if I could find a replica part. 73 Andrew Sent: 21 June 2023 01:18

??????? ??? ??, 21 ????? 2023 ?-3:06 ??? ?Mitchel W2NEC?? <? mitchelrought@...??>:?

From what I have heard this is a common problem. I have heard that shorting the switch contacts to the unused pair on the pcb will get around the issue. But proceed at your own risk. I am sure that a

Hi Mitchel, personally I would not do that, might cause problems with the set and/or psu, I would suggest you fit a switch between the psu and the set in the positive feed lead. Leighton. GW3FSP.

The power switch on my FT-847 is starting to have issues and while I am in the process of locating where to have it replaced, is it advisable to use the power supply to turn the rig on and off? Thanks

Hi Hal, this is a circuit I use for all sorts of data modes, this one I made for my Clansman kit. The circuit is always the same just the wiring details change, it's cheap and easy to make. Leighton.

Thanks for all the replies. Helps lots. 73/Hal. WB4AEG

Hi all, Please see attached what I use, no problems to report. 73, Jorge Em ter., 16 de mai. de 2023 às 19:41, Hal Dale <wb4aeg@...> escreveu: -- *** Help us to save energy & paper - do

Hi Spence Thanks for your reply. It's funny you should mention using an optocoupler. The one I originally built for my FT-100 back then and still use for my FT-817 uses a 4N25 optocoupler for PTT

The ext Speaker option is used if you find using the low level Line Input on your sound card doesn't have enough to drive the software (mainly SSTV from what I remember) as opposed to using the

Nice interface, Ian. Curious, why use the external speaker jack, given that its output is dependent on the front panel volume control and subject to being mis-set? There is a fixed level audio present