开云体育

If memory serves me correctly it was to deal with microphonics

Fellow Frogers, Just picked up a new-to-me FRG-7 and noticed what seemed to be an unkown mod consisting of a DPDT slide switch (S-7) w/ two? resistors (R-18 & 19), connected to the internal speaker.

Hi Andrew, The FL-101 transmitter looks very similar to the FRG-7. But when the FL-101 is used with the FR-101 the pair will work in transceive mode after the interconnecting cables are attached. 73

I am looking for an aftermarket speaker replacement for the main speaker on the FRG-7. Has anyone had success with finding one?

Thanks, Lex, for that 3D-printed knob design. I was lucky enough to find an original knob on eBay. Also, thank Cesar for your reply. This is one neat radio. I am researching a suitable AM transmitter

The knobs of the first model FT-101? look like the on a FRG-7. But the knobs you are pointing to in the e-bay link are from the newer models of the FT-101 (E, ET, Z, MD etc) and look like the one's

Read that ft 101 is the same. Found this:

Hello Andrew, These are very hard to come by. I had the same problem and often 3D print parts, I designed my own (as close as to the orginal as possible).

Wondering if anyone has the main tuning knob they would be willing to sell? Andrew

I should have mentioned my goal is to replace the kHz drum with a 3 digit display

I used some of these many years ago and they were awesome deals unfortunately they are discontinued https://www.pongrance.com/

Thanks but my budget is around $20

Mike M. See the link below which has my review of the Electronic Specialty Products DD-103:

Hi Paolo, Thanks for the display info. I copied your pdf's over to the files section and added translated english versions as well:

Hi, please look at the attached articles (unfortunately they are written in Italian, but almost easy to be read). Good work, regards! Paolo Viappiani

has anyone added digital readout to their FRG-7 this year ?

I just took delivery of a fixer upper FRG-7. I did a full alignment but was still disappointment with the results of this receiver. So I put in on the bench and found that L101 (4 coils on a rod after

Great job Lex, I have two suggestions: I believe that spun replacements for the metallic inserts are available from restoration places but may have to be cut to fit. If you use ABS in black you can

Recently I got a question from a fellow ham if I have a replacement knob for the Fine-Tune. Unfortunatly I didn't but told them that I wanted to 3D design all the knobs of the FRG-7. So during my

I have noticed that the lock light in my FRG-7 dims with humidity. I doubt this is the problem that yitzimarks@... is observing, but I toss this observation in to see if anyone else has seen that