开云体育

Don, kc7ewz, delivered 15 pieces to me this afternoon, Thanks Don!

So, we are all set, for the time being.

On Wednesday, January 13, 2021, 7:39:18 PM MST, Bob k7rnd <bob@...> wrote:

I will have it ready tomorrow afternoon.?

K7RND

On Wed, Jan 13, 2021 at 1:42 PM Harley ki7xf via <ki7xf=[email protected]> wrote:

Has to be somewhat rigid, spans a 3.5 x 6 hole.

On Wednesday, January 13, 2021, 12:13:56 PM MST, Bruce ke7sjz via <ke7sjz=[email protected]> wrote:

How about shim stock?

On Wed, Jan 13, 2021 at 12:08, Bruce Walker

<ke7sjz@...> wrote:

Does it have to be aluminum? I might be able to get that in steel from work as a donation.

On Wed, Jan 13, 2021 at 10:25, Harley ki7xf via

<ki7xf=[email protected]> wrote:

There is an RLC-4 controller at each repeater site that needs a cover plate.

.040 thick aluminum works just great, 4.4" x 7" is the perfect size.

Can cut over sized pieces to fit.

The RLC-4 comes with an enclosure, but have modified it to make adjustments easier.

Therefore, the need for a cover.

I use neodymium magnets to hold the cover in place on the steel enclosure.

No screws, just slide the cover away, make adjustments, and slide back into place.

Need about 10 pieces, a couple would get me by, the rest can wait until later.

ERA needs 4

MRLA needs 3

Any ideas of where there might be some for the asking?

Have checked Pacific every now and then, no luck so far.

Thanks,

Harley