开云体育

I'm back for a while and working on kits again. I put a very high priority on the new Display Driver board that fixes the T41 display freeze issue and allows a nice long cable to the display. I offer

I don't know how long it takes for US changes to ripple through the system. I would write Amazon.UK and try to get an answer. Jack, W8TEE

As per title

It has beeen sold Frank

What I'm looking for is the measuring procedure including the instruments you used to get the 100 dB and 78 dB numbers. I would like to run the same procedure on my radios to see what I get. -- 73

**** I'm guessing -100dBm. dB relative to 1 mW. - Jerry, KF6VB

Well there is no real absolute way its done as you probably know, you first need to determine the noise floor (for the mode) and that is usually the point at which the (S+N)/N = 3db (and of course,

That was changed...don't know why it wasn't updated. Jack, W8TEE

Hi Bill, 100 dB relative to what?? How did you measure that? -- 73 Greg KF5N

“The latest (V12) PCBs are available for less than $5 each on the web site (/g/SoftwareControlledHamRadio). If you wish, pre-fabricated PCBs with all SMD devices already on the

I think this is the correct link: https://a.co/d/7OvoqhH

Ah… old fashion Automatic Volume Control (AVC) dated from the old tube radios…to control the volume of the radio as to not blow out your ear drums… as opposed to RF Gain (or Automatic Gain

if you are in the UK i have a spare set

Yeah another mistake is pulling the wire so tight that is scrapes the enamel off the wire between turns and shorts them together. I am guilty of doing that… Dr. William J. Schmidt - K9HZ J68HZ 8P6HK

Yeah it does... Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois Owner – Operator Villa Grand Piton –

I can see me messing up those I will rewind for grins. Tim

*** Does it tune smooth? No ticks? - Jerry, KF6VB

Doesn't the newer RF board have the solder holes in the middle of the attenuator pads? - Jerry, KF6VB

All: Just heard from Amazon and the updated version is now being advertised: Jack, W8TEE

-78dB? My V11 : with HC125 buffer, no shield on display, and 12V switching power supply