开云体育

Jack, See RXoffset.ino

Sorry for the delay response...busy stomping out fires here. Can you post the code you used for the offset? Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Tuesday, October 18, 2016

I am a little confused my this discussion. I implemented a receive offset function which allows the receive frequency to be offset by a programmed amount (default 600 Hz) from the transmit frequency.

I'm trying to find the discussion of the circuit... Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Monday, October 17, 2016 10:28 AM Subject: Re: [SoftwareControlledHamRadio] Re: RIT

Wouldn't RIT just be a code change when your LO is completely software controlled? What does the hardware pictured do? -Mark

Thanks for the heads up! I ordered your book at the same time I ordered all of the kits/parts. It should arrive this week! I may just go ahead and order a Teensy as I would like to have that feature

My Arduino Projects for Amateur Radio?book has a reader circuit and there is enough flash memory for it in the Forty-9er. However, it is the SRAM that is the issue, as that's where the data and stack

The picture titled Board011 is of a Muppet board that I built. It has the BCI filter on the top, a 24W dummy load on the left, and the RIT hardware on the right. That circuit was from someone who

I conducted a search but was not successful in locating any topics on incorporating a CW Reader. I know others have done it with the Rebel/Patriot transceivers. Just thought it would be a nice touch

Closest I could find was message 348..... "Jack had provisions for RIT but it is not implemented. I had to eliminate the delay loop associated with it to get things going. " But I'll keep looking.

I don't see why it wouldn't work, but I do seem to remember someone who has already added an RIT to it. Take a look back through the posts. Jack, W8TEE To: SoftwareControlledHamRadio@...

Has anyone incorporated a RIT on the Forty-9er? If not, wonder if this will work, or could be made to work? http://www.hamanuals.com/MMans/RIT%20for%20SW+%20Transceivers.pdf

There is a plot of the response curve and the schematic. I don't think you looked back far enough. Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Sunday, October 16, 2016 8:58 PM

You might be interested in this board I made for this very problem: https://oshpark.com/shared_projects/GB9ulW7R -Mark

I see an out of focus picture of the BCI filter but don’t find a schematic. Bob K3CKO Sent: Saturday, October 15, 2016 2:53 AM To: SoftwareControlledHamRadio@... Subject: Re:

Marc, I received the D882s thanks so much for your help!

Anyone who is not familiar with programming and wants a "beginner's book", read the reviews on Amazon.com for Beginning C for Arduino. There are over 50 reviews on the first edition and 11 on the 2nd,

Very good article.. almost the same starting point here.. I have been a licensed ham operator since 1960, and have built a lot of radios, especially the HeathKit rigs.. But this little rig has gotten

Thanks Karl. Many of the items are on the way. I plan to take my time and enjoy each aspect of building and programming. Thanks again for your letter in QST as I would likely not have taken on the

Check the first 5 photos and you'll see it. Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Friday, October 14, 2016 10:36 PM Subject: Re: [SoftwareControlledHamRadio] FORTY-9ER