开云体育

Dave Cripe made some changes to the 4SQRP boards and they were V09 versions. Greg has provided a link to the build instructions that 4States provided that show V09. I thot that some in my kit were

Sure… Hopefully I get better at the code for the design… Its been years since I used G-code for anything. Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner -

By pressing the select/enter button (top left). Roger G8JWT

If you make one for the 7" display, put me down for one. Jack, W8TEE

Check with Al, but I think that was the number we used on the first batch of boards we produced for the Beta T41

Huh well then what is a V9? Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois Owner – Operator Villa

I finally got my 4-axis CNC machine fired up last night and the first thing it made was a box for the back of my radio with a 5” display based on John Lundberg’s work. I’m pretty excited about

Try this: https://4sqrp.com/kits/T41/4SQRP%20T41%20Assembly%20Manual%20-%201-5-24.pdf -- 73 Greg KF5N

Yes, I have the same issue, also when selecting and deselecting CW Rick, KN4AIE Sent: Tuesday, April 8, 2025 12:01 PM To: [email protected] Subject: [SoftwareControlledHamRadio]

I don't think so. That was V10. Jack, W8TEE

Version 9? Not familiar with that… Maybe that was a 4SQRP radio? Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner - Operator Big Signal Ranch – K9ZC

A co-worker purchased a V9 T41, but its not completely operational.? I know this is a few revs back, but is there a (per board) check out/troubleshooting guide somewhere for that rev??? Something

How are you exiting the menu? Jack, W8TEE

Each time I press the enter/select button to select a menu setting the tuning fine increment changes. This only happens when exiting the menu. Just pressing select when not in a menu has no effect.

“The math under the hood in the frequency calibration routine doesn't account for the fine tune frequency offset.” I didn’t catch that either… any reason for that. Seems a bit quirky… Dr.

OK, the direct freq entry was the key.? Freq error on 30M and 20M around 4Hz, Which I think is fine. Thanks Oliver Mark KU3O

Hey Oliver, I select the 30M band and tune to 10MHz using the Tune knob.? I select SAM demod and use the Fine Tune to get the freq error down to the lowest value possible.? Then I start the

Are you saying that if you tune to 10 MHz and select SAM demodulation, you measure a frequency offset of 190 Hz? A gotcha with the frequency calibration is that it matters how you tune to 10 MHz --

Hey 'yall, I'm running a V12, 66.9, TCXO.? I've run freq cal and I'm off by 190 hz.? I've hard coded the cal value into si5351.init as well as 0.0.? The 190 hz error shows against my freq standard

Greg You are correct very easy to over drive 160-80M. I tried lowering input but 6m really suffered. I changed a lot of caps across input to t3 with lower drive but just could not get 6M close. I