开云体育

Been reading about the VFO output level, so I took my scope to it. I set it to its lowest level of about 400mv and the rf OUTPUTvoltage level was very low. The heat sink remained cool. Putting it back

Thank you, Jim. Based on your clue, I lowered the signal on pin 6 down to 250 mV PEP, but still have my click. There is still a fly in the ointment. I hate flies. Bob

HI Jim: I wish I could be of more help, but like I said, in lack the knowledge. I will forward this to him. He just started his semester so I know he's busy, plus we're working on a new project, too.

Hi Bob, I've mentioned that the data sheet for the NE612 specifies 200mVpp minimum to 300mVpp maximum for the NE612/602 L.O. input (pin 6). Using the buffered output on the DDS VFO, I was only able to

I programmed the ATTiny85 first with the Blink example and it worked blinking 6 seconds on and 6 off. Then I tried CapSenseKeyer with a board from a friend and no joy. So, I studied the code and

I will test voltages on both sides of L3. After work I will take the rig apart. It would be nice to have a few test point values from a working rig to help isolate the culprit. Bob

OK. I just wanted to be sure you weren't using the code for an Arduino. Let me review things tonight...probably will get back tomorrow. Jack, W8TEE To: SoftwareControlledHamRadio@... Sent:

There's only one file and it appears to be for both. Bob

Are the voltages on the final reasonable? Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Thursday, August 18, 2016 4:04 PM Subject: Re: [SoftwareControlledHamRadio] Forty-9er

OK...found it. Are you using the code with the Digispark or the "raw" ATTiny85? Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Thursday, August 18, 2016 4:02 PM Subject: Re:

In case that was the cause, I replaced the D882 with a BD139 from W8DIZ. Same problem. Bob

Several others have had that problem. I've dialed my voltage back from my base rig voltage of 13.8V to 12V and I've not had any problems. I did have a heat sink on it before that, but have since

CapSenseKeyer.ino Bob

I had the same thing happen to one of the 49-er kits that I built and another one from a friend--it was a blown D882 transistor in both cases.? de Karl, KO8S

Ok, but there are several files in that download. Which file are you looking at? Jack, W8TEE To: SoftwareControlledHamRadio@... Sent: Thursday, August 18, 2016 3:28 PM Subject: Re:

Idownloaded source code from https://www.mhprofessional.com/product.php?isbn=0071834052 Bob, KF6ABC

Here's 10 encoders for less than $5 including shipping (search: 121993737161): Of course, these are from China, so you'd have to wait a while. Jack, W8TEE To:

I also needed an encoder with threads, and was concerned by several comments from buyers who were disappointed to find out that what they got didn't look like the pictures. I picked up some from this

Hi Dave, Send me you address and I'll send you one.

What source code file are you looking at? I don't remember writing code with PADDLECOMMON in it, but that doesn't mean I didn't...I've probably slept since it was written. Jack, W8TEE To: