开云体育

ServoCat radio control

@a__l All Messages By This Member #6569 Hi. Tell the frequency range of the radio remote control for ServoCat? I'll clarify, this is the "old" remote control. This one was bought before the "new" 2.4 GHz compatible one was sold. Thank
K9RX - Gary All Messages By This Member #6570 The first wireless, designed and introduced in 2003/4 for Generation 1 ServoCAT's (as well as Gen2) operated on 433Mhz. That system has not been available since the main ICs used, a parallel to serial encoder and serial to parallel decoder, were discontinued in 2008. The replacement systems were introduced in late 2009, a few units to finish off the last Gen2's and Gen3 introduction with the very first Obsession 22UC systems. Full production of Gen3 including the WL and WL AB system started the first of 2010.? Gary Myers StellarCAT
@a__l All Messages By This Member #6571 Do I understand correctly that since 2010 this is 2.4 GHz? I have problems with the radio remote control (or radio base). Perhaps this is a conflict with my router.
K9RX - Gary All Messages By This Member #6572 Yes - but that is ONLY for the wireless system that doesn't have an external antenna on either the base or the hand held part. The antenna is internal. Also the channel chosen is not a standard wifi channel - it is far from it and I've not heard of anyone else having issues with routers.? Gary? toggle quoted message Show quoted text ------ Original Message ------ From alg@... To [email protected] Date 6/1/2023 10:24:44 PM Subject Re: [ServoCAT] ServoCat radio control Do I understand correctly that since 2010 this is 2.4 GHz? I have problems with the radio remote control (or radio base). Perhaps this is a conflict with my router.
@a__l All Messages By This Member #6573 Yes, I see the internal antenna on the Leto-M module. I have a not clear problem with the freezing of the radio channel, when all the buttons on the remote control stop working (But they work when the remote is close to the base (~100 mm).?Then after a while they start working(several meters). I determined that this is not a router. The battery is new.
K9RX - Gary All Messages By This Member #6574 I'm confused. Naturally one would not use the ServoCAT system within 100mm of a router - even a meter seems odd and out of place. So are you good - is everything ok?? Note the receiver side of the module isn't going to be the highest tech out there - it can be overloaded by the presence of a strong signal (the router is MUCH higher power with a higher gain antenna compared to the transmitter of the other module)... so even if the channels were clearly different, and I'm sure they are as the default channel is not on a standard wifi router frequency, it would stop functioning.? Gary? toggle quoted message Show quoted text ------ Original Message ------ From alg@... To [email protected] Date 6/4/2023 11:49:38 PM Subject Re: [ServoCAT] ServoCat radio control Yes, I see the internal antenna on the Leto-M module. I have a not clear problem with the freezing of the radio channel, when all the buttons on the remote control stop working (But they work when the remote is close to the base (~100 mm).?Then after a while they start working(several meters). I determined that this is not a router. The battery is new.

Previous Topic Next Topic