开云体育

Hi Wes, It does appear to be a power issue. When slewing with both motors at the same time, in slow speed, it is successful. Using full speed does stall. We run on 110v grid power, not a battery, Gary

Hi Steve, Mike will get you fixed . I would like to make comment though . If push to works fine but go to doesn't an analysis may suggest a power issue?? Have you checked volts at the scope before and

Just checking if anyone else is planning on attending the PSSG this year. If you’re interested in visiting the astronomy village, the Atlanta Astronomy Club hosts a Peach State Star Gaze each year

Steve, My neighbor has the same setup as you. One time we had a similar problem. At that time, we found that our wires serving the power with the wires serving the ServoCat handheld and Argo Navis,

Ok, I’ll un-invite myself this time. BW

Buster, She doesn’t do GoTo usually. We did try several years ago, and it failed the same way it does now. Since it was not an important part of her observing, we didn’t follow up on the cause.

How well did it work last time used

HI Mike, Thanks for that thought about the wires. But our wires are not getting tangled together. So that is not the issue here. But thanks again for offering that. Steve Goldberg Sent: Wednesday,

Steve, Sorry for the late approval. Good to hear from you - I hope you are doing well. So ... if I read this correctly you're saying if you select SLEW on the hand pad (Gen2? If so slide switch all

Hi, We have a 15" Obsession with both ServoCat and Argo Navis. We have a problem when we use GoTo on the hand paddle. After about 3 seconds the motors hard stop and there is a beep. Pressing GoTo

I could use a spare as well Shyood@... Thanks I live on an ever expanding frontier of ignorance.

hey John - wrote to you direct... g.

Hi Gary, I'll take a spare HC. John

Sold out of the wireless HC's ... have a few Gen3 wired hand controllers left... if you want/need a spare now is the time! Contact me direct rxdesign at ssvecnet dot com Gary Myers StellarCAT

Greetings, Is there a posted procedure for installing the NEW Driver? Clear Skies, Bill L.

will do - going out direct Gary Myers RXDesign

Hi Gary Could you sent me too a list of things to check. I experience the same problem of loosing power when rotating the scope; I already suspected it to be an issue with the powered ground board.

Al,? list of things to check being sent direct... Gary

I have 18 in obsession, with AN SC. The batteries went dead so replaced them as well as the coin (2020?} backup battery, now after alignment the telescope will only do go to’s to the north eastern

Gary, I have the same issue with a 15" Classic. Power cuts off and on when rotating in AZ. Could you please send me a list of things to check? Much appreciated, Al