开云体育

Paul, I now understand. I could do it that way as I use a stand attached to my dob that holds a 15" laptop. The issue I ran into no matter is that Nexus didn't have a way to communicate with Peter or

Mickey, I am not exactly sure what you are asking but I can explain my set up. I have a Dob with a ServoCat version 3 and the AN.? The AN connects to the SC through the AN serial port and the SC

Hi Gary: Not the dsc, it was not connected. I will talk to Bill. Best Regards, Tim

Tim, There are two potential causes of what you describe. First some background. When I decided to design the ServoCAT I needed a DSC to 'talk to' ... and as it turns out the Sky Commander had a

Good Morning Gary: I am having a servo issue, the servo will runaway, I can get it to stop with the hand pad.? It will also make short move ( about half a turn on the servo output shaft) about every

Accessories servocat.comScroll through accessories to find it. Mickey

I t would something like this sitting on top of or attached in someway to the main unit.

I do not know what that is.

Hi Hugo, You should be able to connect via ASCOM to test connectivity. Are you sure com3 is correct? You should go into device manager and see what com port is being used by servocat and then make

Is anyone using dobs and having success with this Sharpcap method of going thru the planetarium computer (argo nav) or (nexus)? If so how? I know of no way to connect directly to servocat with a

Do you have the remote antenna that is for receiving the signal from the wireless handpad?

I bought a wireless handpad with my Gen 2 Servocat system. It has not been used in a very long time. Think pre-covid. I have replaced the battery on it and now the lights come on, but it does not do

Hi Mike from Virginia, Very interested in your results it got me trying to do the same. I have a question for you. When you connect your PC via USB to the ServoCAT box with the Peter Eschman Driver,

Version 7.0C is available on request by emailing me at bill at servocat dot com ( bill@... ). Please include your serial number from the back of the control box and indicate what GEN you have

Where is the version 7 update for servocat located? Mickey

There is always at least one flat on the shaft. As mentioned I don't remember which size scope Richard has. The 15/18UC's both have a 1/4" shaft and thus there is only one flat and one set screw. One

I would like to see a close up pic of the shaft of the area the set screw makes up to. In previous Tool and Die work says a small flat ground or filed onto the shaft gives the set screw more area to

yes indeed that works! The outside one only need be 1/8". Good suggestion - thanks Bob. g.

Richard. In a previous life another common fix we used for setscrews in high vibrations situations is to stack them. Not really high vibration but should work. Just remember if you need to remove the

Richard, Looks nice - however its totally unnecessary. The design I came up with will hold, far far too many in the field with very very few complaints of issues with the set screws to say otherwise.