开云体育

Sold out of the wireless HC's ... have a few Gen3 wired hand controllers left... if you want/need a spare now is the time! Contact me direct rxdesign at ssvecnet dot com Gary Myers StellarCAT

Greetings, Is there a posted procedure for installing the NEW Driver? Clear Skies, Bill L.

will do - going out direct Gary Myers RXDesign

Hi Gary Could you sent me too a list of things to check. I experience the same problem of loosing power when rotating the scope; I already suspected it to be an issue with the powered ground board.

Al,? list of things to check being sent direct... Gary

I have 18 in obsession, with AN SC. The batteries went dead so replaced them as well as the coin (2020?} backup battery, now after alignment the telescope will only do go to’s to the north eastern

Gary, I have the same issue with a 15" Classic. Power cuts off and on when rotating in AZ. Could you please send me a list of things to check? Much appreciated, Al

I'm confused. Naturally one would not use the ServoCAT system within 100mm of a router - even a meter seems odd and out of place. So are you good - is everything ok? Note the receiver side of the

Yes, I see the internal antenna on the Leto-M module. I have a not clear problem with the freezing of the radio channel, when all the buttons on the remote control stop working (But they work when the

Yes - but that is ONLY for the wireless system that doesn't have an external antenna on either the base or the hand held part. The antenna is internal. Also the channel chosen is not a standard wifi

Do I understand correctly that since 2010 this is 2.4 GHz? I have problems with the radio remote control (or radio base). Perhaps this is a conflict with my router.

The first wireless, designed and introduced in 2003/4 for Generation 1 ServoCAT's (as well as Gen2) operated on 433Mhz. That system has not been available since the main ICs used, a parallel to serial

Hi. Tell the frequency range of the radio remote control for ServoCat? I'll clarify, this is the "old" remote control. This one was bought before the "new" 2.4 GHz compatible one was sold. Thank

reply direct only please. rxdesign at ssvecnet dot com garymyers at power dot net

Gentleman, I have a limited supply of these Generation 3 (front panel left side "PC USB" port) controllers: A) wired hand controller? $199 B) Wireless AutoBASE hand controller $469 Both plus S&H.

Hi Dave -? long time no hear. I hope you are doing well. Ok - so indeed this is a ServoCAT issue and has nothing to do with the Argo Navis. It also has nothing to do with ALL connections with one

After many years of storage in a dry shed, I’ve been trying to get my 15” Nightsky Dob fitted w/ ServoCat Jr. up and running again powered by a 9AH gel cell battery.? It was working fine the

this is the video that created my servocat wish list https://www.youtube.com/live/ypheEr4Vv-8?feature=share dave

I'm very sorry to hear of the death of his wife - and for that matter the issues. Unfortunately I can't control the installation - I ship the components and have specific installation instructions but

Yeah, whatever's clever. If it works and it's fast, all is good. You have probably read all about Jeff Gortatowski's loud and constant complaints on the Obsession Beach) for first light in LBV with