开云体育

Check the powered ground board hardware. I suspect you have a loose plate screw making an intermittent connection on the bottom plate. I had a similar problem and added thread locker to prevent my

Hi Paul, First of all don't forget you can always reach out to us directly by emailing sales@... I then see those emails immediately. It will almost certainly be a power

I am using a SC V3 and an AN with the latest firmware.? My last 2 or 3 outings have been cut short because when I am moving my scope manually with the SC handpad, the scope suddenly stops moving, the

Hi Richard, Feel free to email us direct any time. :) Progress has been made but unfortunately the global semiconductor supply chain issues are impacting just about everyone right now who manufactures

All, Has anyone heard if Gary Kopff has made progress on his project? Although, I have to say I am a very happy customer of ServoCAT and observe remotely after I set "from planetarium" mode in the

silicone spray its sold at walmart and others in auto or hardware these days. Shake the can well , just a small amount does the job, any excess wipes off easy. Sent: Monday, November 28, 2022 10:04 AM

What type or brand of fine silicone mist do you use. Do you simply spray lightly on the buttons and let it kind of penetrate? Thanks Cale

Thanks Roy. I might give that a try

I have fixed all the sticking buttons on all the different hand controls over the years with fine mist silicone, they never stuck again. roy in montana weather Sent: Sunday, November 27, 2022 7:54 PM

Nope exactly same as you.

Hi Mike, did we misunderstand ? I've had my buttons physically sticking too.

My Gen 2 ServoCAT with the then “new” wireless transmitter/receiver and wireless Hand Controller dates from 2009. About 4-5 years use the wireless HC “CW” button began to stick. I sent it

Thanks Claude. Yes I’ve had my servocat for 14 years now and after my original Gen 2 buttons began sticking I upgraded to Gen 3 handpad when it was available. Now they are sticking. It’s not the

Hi Mike, I've had my buttons sticking and runaway one after the other, like yours, in 2010. Not sure which version it was, it's a wireless handpad. I did find a similar button and changed all 4, I

Mike, Seems very odd and I'd almost say a coincidence, not related to the HC. There's little there that can cause that unless somehow the button got physically stuck down. I try to ensure that the

Hello Gary, I was using my scope last night (Gen 2 with gen 3 handpad and latest firmware). When I was pressing the right button (I think CW) it got stuck and I had a runaway scope. I tried pressing

Good morning Frederic! If the unit on the 15 is black in color that is a Gen2 which started production in 2005 and ended around the end of 2009. Thanks for the well wishes... we'll be here for support

Hi Gary, thank you for your reply. I have two obsessions and my classic 15 is equipped with a gen1 I think, I got it well before 2010 :-) and it is this one I plan to drive with ASIAIR. I take this

Hello Frederic - I hope you are doing well sir! So ... you will need to switch the AN to "From Planetarium" to go GOTO's from a planetarium program. The command is read if you don't do that but since

Hello all, I plan to configure my obsessions telescopes (AN/SC) with Asiair pro to operate remotely and try some astrophotography of planets with my DSLR (Canon EOS60). Has anybody succeeded to let