开云体育

Thanks for the reply's. I got the same answer from Boxer 2 valve.

I suppose it depends on a which hand has the worst arthritis...but I wish I had an "easy brake" for my right!

I did not. It has to be clean to fit inside the sleeve you see on the end of the chain. It’s held in place by the 3 small set screws. I happened to have a pair of cable cutters from my deck cables

Almost forgot, if you pull the flywheel you must block the crank back to prevent an internal thrust bearing from falling off. Richard Chawes

David, Thanks so much for the photos. I appreciate the time it took to share these. When you cut the cable, did you fit a cable stop to the end to prevent unraveling? Harold [email protected]> wrote:

No, but there are lots of challenges. The pushrods have to come out so you can pull the lifters out of the way which means removing the rocker arms which means the cylinders are now loose. You may be

I agree Rob, I just start off in fifth gear and never see the need to shift. Can’t understand what all the commotion is about. Seriously, the clutch on the R90S has never bothered me in the least.

Here’s a few photo’s I took after the install. I called Richard for some clarification, but best to cut the cable right at the end, then hold up the chain and the sleeve with the 3 screws to

Is it necessary to pull the motor to install a camshaft if you are a experienced mechanic?

I'd love to see picture, not only of your R90S, but of some of the horses you've had. James Wiseman ProServUS Investigation PO Box 802 Burlington, IA 52601 319-750-4199 The truth will set you free.

attached. Hello David - it would be great to have your photos in the Forums. If you send them to me, I can upload them, or you can upload them if you have time to figure it out. Thanks. Ran Bush Nor

Frank, You can trim the stock cable to length by cutting off the end bulb. A little tricky to measure and keep the cable from fraying. Best regards, Kirk Ratzel

I will appreciate seeing photos as well. EZ clutch is on my short list and I’d rather learn vicariously than make an error on this bike. Don’t ask how many jobs I’ve had to do twice to get it

I would be happy to see photos. I have tried to install it, but I couldn’t, there weren’t room for my hands. And I cut the wire too short….. Yours Peter Sendt fra min iPhone Den 7. jul. 2021 kl.

It requires cutting of the cable. I have another type on my other R90s which required no cutting, but less experience with it. Th EZ Clutch going on 20 problem free years. Best regards, Kirk Ratzel

I’m interested! Bought one over winter haven’t installed yet- Thanks!

I just installed the easy clutch yesterday on my R90/6. I must say it’s one of the best mods I’ve installed. It’s an amazing difference. I was blessed with rheumatoid arthritis a few years ago

But…sometimes my K1 can get as much attention as my “S” Bob Alexander Sent: Wednesday, July 7, 2021 5:13 AM To: [email protected] Subject: Re: [R90SWORLDNET] riding In 34 years not a single

No…installed mine this Spring. Make sure you tighten the lock nut!(red below). I forgot and lost my cable connection on mt second ride. Glad I was only 10 miles from home and shifted clutchless. Bob

Kirk Does the Easy Clutch requires to replace the clutch cable? Frank Down Under Sent: Wednesday, 7 July 2021 9:15 PM To: [email protected] Subject: Re: [R90SWORLDNET] clutch THE must have