Re: Field Day Logging
Roger, I have it on one laptop. I will follow the link and upgrade. TNX - KD4SHH
By
Rice David
·
#61
·
|
more cw stuff
After reading the manual on message orientation and ESM (Enter Sends Message) mode, I have one question. When I type a call sign into the "CALL" field, hit ENTER, the cursor stays on the CALL field.
By
Jim Nail <james.nail@...>
·
#62
·
|
More...
Mike, I'm assuming you are planning to use the PC CW generation in WriteLog plus a paddle connected to the Built In CW Keyer in the ICOM 775, correct? I noticed there is only a KEY jack on the back of
By
Jim Nail <james.nail@...>
·
#63
·
|
Re: More...
Jim, Yep, we should use the PC to key in normal use. I use the standard conventions for field movement and entry. Spaces or tabs move from field to field. "Enter" makes the log entry. I use the Fkeys
By
ne4s <mike40@...>
·
#64
·
|
Re: More...
Spaces use ONE Yes, I think this works well. F10 is the exchange like %C %BB4%B 7A GA K. This dupes the call and sends "B4" if a dupe without sending the exchange. Then you would go on to a TU N4N
By
Jim Nail <james.nail@...>
·
#65
·
|
ICOM 775 DSP operators manual
all, the ICOM 775 DSP operators manual can be found at: http://www.icomamerica.com/support/manuals/ic-775dsp.pdf 73 de tom kt4xn
By
Tom Crowley <tomcrowley@...>
·
#66
·
|
Writelog Info
Here is a link that I recommend to all using Writelog. http://www.k9jy.com/ Please take a few minutes to look at it before FD. 73 de KN6RO
By
Roger Hackler <rhackler@...>
·
#67
·
|
Reminder--Roundtable on 2m tonight at 9:00pm
Just a reminder that we'll convene again on 147.105 again tonight at 9:00pm for the final scrub of the plans for Field Day! Hope to see you. Dave Moss Manager Radiological Protection Group (770)
By
Moss, Dave J \(INPO\) <mossdj@...>
·
#68
·
|
FW: FD
Hey gang, It's getting to be crunch time for making a decision on whether to use Phil's trailer (designed to be a big horse trailer) to contain 4 stations, or to use the tent I got at the 'big tool
By
Moss, Dave J \(INPO\) <mossdj@...>
·
#69
·
|
Re: FW: FD
I'd vote for the TENT... the confinement of the trailer (metal, at that) will be VERY distracting for 4 operators... I like your idea of setting-up the tent on Thursday... if at least adequate, then
By
Mike Lee <mikelee@...>
·
#70
·
|
Tent/trailer...
Message"Plan for the worst, hope for the best." I like your idea of going with the tent first. Give it a good test Thu/Fri. If it works, well, it works. The trailer can be a backup.... 73 de JG
By
John Grimsley
·
#71
·
|
Re: Tent/trailer...
I'm a tent man. Tim WO0LY Message"Plan for the worst, hope for the best." I like your idea of going with the tent first. Give it a good test Thu/Fri.. If it works, well, it works. The trailer can be a
By
Timothy Turco <timothy.turco@...>
·
#72
·
|
Re: FW: FD
MessageI also must vote for the tent. A trailer can get noisy and hot. Eric
By
Eric Howell
·
#73
·
|
Re: FW: FD
MessageEspecially if one of the OPs has four legs...and a tail! :-)
By
John Grimsley
·
#74
·
|
Trailer info..
I agree that the trailer will be noisy but will be cool in the summer with the air going and a small fan. I also agree that a tent will be a nicer setup and will allow for more (natural) air flow; as
By
Phil West <phil@...>
·
#75
·
|
Wireless LAN Access Points Configured
I have configured and tested two WLAN APs. Here are the details for those that wish to pre configure. AP #1 Linksys 192.168.1.16 AP #2 Cisco 192.168.1.15 Subnet Mask 255.255.255.0 SSID n4n WEP
By
Rice David
·
#76
·
|
Re: Trailer info..
Phil, Are there pictureon your web site? ....daverice summer with nicer are no is needed questions forward-most living front and
By
Rice David
·
#77
·
|
Absent, Braves won
Well, I forgot about the radio roundtable... Braves won and I went to bed. This was probably covered... Jim Nail and I tested the CW station and computer keying on Sunday. It all works fine. We also
By
ne4s <mike40@...>
·
#78
·
|
Re: Absent, Braves won
THe serial interface for the 775 is packed and ready to go. 73 de Tom
By
Tom Crowley <tomcrowley@...>
·
#79
·
|
12 volt rig?
I heard last night on the net we don't have many 12 volt HF rigs. I have a fully stocked (including crystal filter - good for CW) Kenwood TS-850SAT. He doesn't like 110 VAC. He LOVES 13 VDC! IF this
By
Tim Lemmon <tim_lemmon@...>
·
#80
·
|