This is the second posting on the same problem that I thought had been resolved., But it¡¯s not. ?
I¡¯ve narrowed it down to something that I believe might be causing Mach3 not to work.?
?
Configuration: windowsXP, PMDX122 parallel port motion controller, Taig desk top mill.?
?
Been running this configuration for years and all of a sudden it quit working.?
?
Tried lots of things to get it running again, with no success.?
?
Here is something I think is unusual that may lead to the solution .
?
When I run the diagnostics with Mach3 and I click on the ¡°mist toggle¡°, the red ?light on output #4 flashes on and off. See attached photo.?
?
This should not happen since I do not have output # 4 enabled in the ¡°output list¡±, see attached photo.?
?
Any suggestions would be greatly appreciated,
Chuck?
?
