开云体育

Thankyou Ron The problem was in fact the cable, which I mistakenly thought was a 'straight-through' type but was in fact a 'crossover' for connecting two computers. David

I am converting to M3, and trying to control a spindle with step/direction and a VFD. I have the pins set to the same pins as M2 and active low, duplicating my functional M2 setup, but I get no

Steve: Did you name the modded screen .lset? Im wondering if your in Turn mode, the .lset is what switches it to Turn.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com

Hi Jacques: It shoudl save the last one used, but we've changed alot onm the last couple weeks. We'll check it out.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com

Hi Mario: It is not yet active, Im turning it on this weekend, should be out around Wed. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map:

The zero part offset button works on the Lathe screen that comes with Mach, but on my modded screen I can't get the damn thing to work, I only copied the buttons from the original to my screen :-( All

Ok Art, I will further investigate. I will keep you informed. Thanks a lot for answering my questions, Manu (@manu, manutoys, vantiv)

Hi my question is layer control when i open dxf file is any way to make default setting for deep, rate rapid height or it came from auto cad setup thank you jacques

art wrote: I've got to pick up the kit next week and then I can have a proper play. I don't officially take over until 1st July, but things are moving quicker than originally planned :) -- Lester

Art: in relise 040 I found the new modbus configuration : if this active ? how can I get information on how to use it ? Thanks Mario

from to a Tom Two possible routes: (a1) Set the input to be an OEM trigger with code 301 (a2) Use the SetTriggerMacro in your initialisation to link all buttons with 301 into a given macro (say

Hi Tom: Sorry, I meant to respond to this earlier. You need the SetMacroTrigger() script call. Calling a user script is a bit of a kludge. You call SetTriggerMacro( MacroNumber) , the macronumber is

Hi: No, normal relase just includes the JoyStick dll. Only programmers need the SDK installed there. The SDK is a spearate download.. Thanks, Art www.artofcnc.ca Videos And Support Forums

Well it is some process running that stops things. You will then convince yourself that Mach3 cannot work at all :=) The Bresenham algorithm gives average pulse rates that can be set at much finer

The video says the sdk files will install in the plugin folder the only file i have there is the joystick, do i need something else?.. Thanks

Does anybody know (or suspect) a way to call a button activation from a input for a user defined button. You need a number to call and I can't find any number ID for user made buttons. I want to be

Does anybody know (or suspect) a way to call a button activation from a input for a user defined button. You need a number to call and I can't find any number ID for user made buttons. I want to be

Hi Manu: If setting the scope to 2ms shows the right signal, and otrher setting do not, then the scope is confusing you a bit. (Mach's not going to change the signal based on the scope setting..:) )

HI Lester: The speed of the computer is usually unimportant as long as it is over about 800Mhz. The periodic pulseing or surging sounds like a process interferance. Did you run the drivertest.exe to

Hi Dean: I cannot reply to your questions, your email bounces back. Can you try another email address.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map: