开云体育

fauffing, We at PMDX have not seen any communications from you since your PMDX-411 purchase. Hopefully we are not the source of your frustrations. If you do decide not to use the PMDX-411, you can

Yes sir... that probably is illegal, and is certainly against the vendors terms of transferring licenses. I do appreciate the offer, but bad karma from my perspective. Ironically, I was going to buy

This is probably blatantly illegal, but I have a Mach3 license file that I don't use. I use Mach4 now and will NOT use Mach3 again. I don't know if you can just use someone else's license file, but

I don't think I've ever posted to this group before, but I have to say I am so frustrated with trying to receive a copy of my license from Mach Support after a hard disk fail that I'm about ready not

Thanks, man! Sent: Wednesday, April 28, 2021 10:50 AM To: [email protected] Subject: Re: [MachCNC] Mach4 Coil Winder Screen Good news! They have been working on the webpage and they have showed me

Good news! They have been working on the webpage and they have showed me where it is at now. They are ironically working working in the screen page now. The plugins page looks really nice. This is

Good question.... BRB ______________________________ Brian Barker Engineering / Devlopment ArtSoft | Newfangled Solutions Livermore Falls, Maine (USA) Phone: 207(618)1449

Hi Brian: Any word on this? Sent: Monday, April 5, 2021 8:01 AM To: [email protected] <mailto:[email protected]> Subject: Re: [MachCNC] Mach4 Coil Winder Screen They have it and I asked them to send

Hi Dale, And big thank you for your research. The video is great, but it’s showing an older version of mach4, which doesn’t even have the troubled diagnostic screen. Happy chips! Konrad Am

Check this out. I found it helpful. https://www.youtube.com/watch?v=iyvOAF5_vtg&t=2s Dale Grice

Hi all, I’m just trying to set up a small modelmaker lathe with Mach4 and a Pokeys 57CNC board X and Z axis are running, homing works, Spindle is turning CW and CCW and so, I’m already quite

Hi Brian: Any word on this? Sent: Monday, April 5, 2021 8:01 AM To: [email protected] Subject: Re: [MachCNC] Mach4 Coil Winder Screen They have it and I asked them to send it to you months ago! Blah,

Nice to hear from you again Dale. I bought a small router from one of the Chinese vendors on Ebay. There are dozens of them, and if you look closely you can tell the ones that are made with heavier

That sound like a fun tool. You should have no trouble finding linear reals and ball screws. I am internet compromised right now or i could give links. Automation technologies maybe? The z axis is a

I am curious if anyone knows of a good XY table that I can connect my Mach 4 and CNC box to. The situation is, I've always wanted to get in to CNC. I got into the retrofit of a little machine shop

Thanks for your opinions.

Thank you all, it switched as soon as I? loaded up my xml profile.? Evidently this is something I must have struggled with about 10 years ago when I made up the original profile and had completely

also G90.1 or G91.1 switches it if you have it in your code.

Steve, its under config/general config? second column over like 3 boxes down. I J mode absolute or incremental. whichever is checked switch it. Chuck