开云体育

Andre, I am sorry you are still having problems. It appears your issue is tied to tool height compensation. I suggest you experiment with limited code until it is worked out. When I was learning I

I do not know if I am allowed to post a RFQ/RFP on this forum but, I am at the end of the line – for some reason Mach is working on my nerves and seems to get a kick out of it. When using Vectric

RK, How have you determined the length of your probe? You would have a constant offset such as this if the length is off by 0.015. Charlie <mach1mach2cnc@...> wrote:

My mach3 works at 45khz. Every 5 seconds or so the frequency drops to 200-300hz then goes again to around 45000 . But i have never had problems regarding this. It started doing it since some version

I realise that this is not an answer to why the error is present, but if the error is consistent, then have you thought of lying to Mach and telling it that the plate is only 0.06374" thick. ---In

Yes, and no. It depends on the motion controller. So, for example swapaxis was not a solution with the smoothstepper (not supported), On Mach3. It will hopefully by easy and standard in Mach4. I dont

i don't have an answer for your specific problem but i do want to say that Mach3 is ready for a production environment. the machine i just built has just one screen with everything needed on it

The more I use Mach3 the more I am getting confused and worried that the software is not ready for a production environment. I have this sample code. I have in my tool table 5 bits defined with only

Hopefully I will state this in terms that make sense. Can Mach3 or Mach4 change modes on the fly? E.G. Can I change from a spindle(lathe) to an axis(indexer) without quitting and reloading a different

I have recently installed the Big-Tex Probing screen v3.2 which seems to work absolutely fine. However, after much testing now, I am getting a consistent error in that, once I take the touch plate

that is the same PSP i bought. only ORIVeDA seemed to care about testing and publishing the results. i was not impressed with most of the products mass marketed in health food stores. the routing

Spencer, You’ve made day to hear about the benefits of Turkey Tail from someone who’ s not trying to sell it to me. I buy my mother this...

Hi Dave, Excellent job, I like it.:-)) There's a lot of chips around there, how did you know I didn't pay my attentions to chip conveyor? And the holy grail of conflict (MPG) is missing.:-) Thanks for

i took turkey tail extract (PSP) while undergoing radiation treatment for prostate cancer and had virtually no side effects. i still take it daily just to be sure? turkey tail is one of the most

sick? i thought someone finally understood my needs in a CNC machine. i need a few more details in order to finish mine. what species of mushroom is best and is the mounting angle of the stepper

you have a very sick mind Dave.....LOL

From 8 mins in. Be prepared to shed a tear...

That could be so, or they could be something else in my head.... I've been trying to grow mushrooms in saw dust. Lions Main mushrooms have a unique protein that can cross the blood/ brain boundary and

that is perfect and green too. i assume the mushrooms turn the wood chips into compost. -- Best regards, Spencer Chase 67550-Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA

How should Mach know how far you need to lift your Z axis?? That is a function of your set up on each job. On some jobs you may need to raise higher to avoid clamps or fixtures, etc. You need to set