开云体育

the VB IDE from VB. or page to the refresh by the redraw getting violation

a dimensional some scanner clueless Your best bet is take the original part and measure it and draw it on a simple CAD or illustration program. The issue is not ususally duplicating a flat part

It doesn't sound like you have Estop problems anymore so how about changing the subject line to "I got more toys than you do" so I can delete it before I waste time opening it.

clueless Do you mean parts you will be making with the plasma cutter? I.e. someone brings in a sample and says 'make me 10 of these, but I don't have a drawing"? If so, sounds like you need a touch

If you have a part, say a bracket, but don't have a drawing what's a good what to get it into mach1? I'm just talking about 1 dimensional parts for the plasma cnc I'm building. I've seen different

Hi all, Especially Art, you can get one of these I'm sure. My friendly X-Ray repair guy brought me more treasures yesterday. In the pile of stuff was another vertical tube stand with the collomator

What a sick group we are. wrote: computers all... 3 2.3Ghz... downstairs, and a London, 2 more

wrote: that can over to Gavin, I have recently purchased a new ShopBot and have not cut anything with it yet. As soon as I installed the software it became apparent that the thing to do is replace it

Racks, got one, though it's full of mostly whole house audio and automation equipment, though there are 4 pc's in there (one server and 3 mp3 players...) touchscreen computers in every room (plus

Alan - Where can we see photos of this project? Scott Scott T. Carter i-3 corp. 500 Orange Str. Georgetown, SC 29440 Ph. 843.240.0173 Fax 843.545.8585 e-mail Plastiguy@... do no harm

Hmm, 4 machines running in this room, 2 and a laptop downstairs, and a whole 19"/42U rack stuffed with servers at a colo facility in London, 2 more machines in at a colo in Lausanne ... You aint a

I know this is slightly off topic, but I was hoping there might be some experts here. I am creating a toolpath in Mastercam and have the clearance value on my Contour set at 2". However, when I post

Hi all, I have been using Mach2 to run my engraver and ,after the initial configuration bugaboos(No fault of the software), I have to say that this software freakin' ROCKS. I also own a shopbot PRT

Hi Art, There is still something wrong. If I compile the program then run the exe it mostly works. If I try and run the program from within the VB IDE then VB bombs with a protection fault. There are

have a I wish that you get better! Best Regards, Daniel.

Peter: If you write an VB application with a button on it that calls StraightFeed ( 10,10,10,0,0,0) in it does it move? If not, send me the application, I can debug such a thing quite easily and see

Daniel: Thanks, I'll look into it, I'm running slowly this week as I have a flu.. Thanks, Art www.artofcnc.ca

James: You cannot run Mach2 at the same time as your VB application. When you use an OCX, you must have exclusive use of it. Send me an offline message so I can send you a small VB application which

Peter, I was able to get the Master5 ocx to work by naming the OCX instead of: Private Motion As Master5Remote So much for reading books! Thanks for the help! I'll work with the Master5 OCX for now.

Peter, Thanks for the post - I think my first mistake was trying to use Master5 OCX. I downloaded the demo for Mach 2 Rev 4.0 lockdown to try it out. I created a new form in VB5 and followed your